Humax PVR-9150T User Manual - Page 57

10. Installation 10.3 Default Setting Default setting restores the product to the default settings. Warning: Please note that once you perform default setting, all data such as channel list and user configured data are deleted, no information on the HDD will be lost. 1. Press the MENU button. 2. Select Installation using the / button and press the OK or button. 3. Enter the password using the NUMERIC(0-9) buttons. 4. Select Default Setting using the / button and press the OK or button. 5. Select Yes and press the OK button to restore all setting to factory default. Select No and press the OK or BACK button to return to the previous menu. 6. Confirm again to start loading default setting. Enter the password using the NUMERIC(0-9) buttons to perform restoring. 7. When completing the default setting, press the OK button to automatically run the installation wizard. For detailed information about the installation wizard, refer to Chapter 3. Installation Wizard. Tip: The default password is 0000. If you have forgotten your password, please contact your local product distributor. 10.4 Antenna Power Make sure to set the Antenna Power to On when you connect an active antenna to the ANTENNA IN connector on the rear of the product. 1. Press the MENU button. 2. Select Installation using the / button and press the OK or button. 3. Select Antenna Power from the installation menu using the / button. 4. Press the OK or button to select On/Off. On 5V power supply from the active antenna cable. +5V/50mA (max.) Off No power supply. Note: • Active antenna is a portable or indoor antenna which needs power supply from the product because it does not have power cord for itself. GB56 User's Manual