Humax PVR-9150T User Manual - Page 66

13. Appendix 20. When I try to edit a recording I am unable to use the 6 function buttons on the bottom left of the screen. • To use these buttons press the PAUSE button on the remote control, then use the arrows to navigate to the function buttons. 21. I am trying to download the software via my PC but it will not start. • When you receive the message ˇ°Waiting for Humax connectionˇą on your PC, make sure that the cables from the PC to the PVR are connected, and then power the PVR on from the rear ON/OFF switch. 22. I get a message "E-OS" (or E-05) on the front display every morning. • This message will appear when the PVR has tried to download the software automatically but the download has been corrupt or failed. To resolve the issue see the instructions on how to carry out a Default Setting. When the update is released again the PVR will update automatically. 23. The Installation menu is greyed out when I access the menu. • It is not possible to access the Installation menu when you are playing back a recording or when a recording is in progress. You will need to stop the playback/recording to access the menu. 24. When I switch my PVR on I receive the E-AC error message. • This error is caused by corrupt Application software; see the Software Download section for more information. 25. When I access the menu I no longer have a record icon in the menu, instead the menu options start with Preferences and Games appear at the bottom? • When the recording icon does not appear in the menu then the HDD has not initialised on start-up. Power off the PVR from the rear ON/OFF switch for 2 minutes and then power on again. If the record option is still no longer available please contact the Customer Helpline. 26. How do I change channels on the PVR? There are several ways to change channels, see the Channel Change instructions for more information: 1. Enter the channel number using the numeric keypad on the remote control. 2. Using the CH+ and CH- buttons on the remote. 3. Press the OK or LIST button on the remote to display the channel list, use the or arrows to navigate through the list, press OK to change to the channel you require 27. The Time on my PVR is not correct. • Go to MENU PREFERENCES TIME SETTINGS menu and change the GMT OFFSET in 1 hour intervals until the correct time is displayed. If the time is only several minutes incorrect then this may be an issue from the transmitter as the time is detected from the Digital Signal. 28. When my PVR is connected I am not able to receive any/all of the channels on my TV. • Check that you have a RF (coaxial) cable connected from the TV/VCR output on the PVR to the aerial input of your TV set. • If the problem is experienced when the PVR-9150T is placed in Standby mode, then please access MENU PREFERENCES MISCELLANEOUS SETTINGS POWER SAVING IN STANDBY - switch this option OFF so that the signal will be passed through to the TV when in Standby mode. 29. My EPG takes a long time to load each time I switch the PVR on. • The PVR does not store the EPG information in standby or powered off, instead it refreshes the information each time you switch on. The time take to populate all of the information may depend on the channel you are tuned to, it is recommended to go to BBC 1 where the information will be downloaded quicker. GB65 User's Manual