Humax PVR-9200T User Manual - Page 62

10. Installation ** This chapter describes how to search for channels and other series of procedures. 10.1 Automatic Search If your product is connected to the aerial and television, you can automatically search channels without entering any other information. 1. Select MENU button. 2. Select Installation using the or button. button and press the OK 3. Enter Password using the NUMERICAL (0-9) button. 4. Select Automatic Search from Installation menu using the button and press the OK or button. 5. Automatic channel search begins. Note: The Default Password is 0000. ** Search Wait while channel search continues. This may take a few minutes. 1. During operating search, the cursor is located at Stop . Therefore, if you press the OK searching, the operation is stopped and the channels found until then will be displayed. button during 2. If search operation is successfully completed and the channel does not exist, press the OK reset the search operation again if necessary. button and try to 3. You can delete unnecessary channels from the searched channels. Select your desired channels to delete and press the OK button. Then select Delete and press the OK button. To delete all channels, select Select All to select all channels, select Delete, and press the OK button. 4. When completing Channel Search and deleting unnecessary channels, select Save to save the changes. GB 61