Humax T2500 Users Guide - Page 23

Setup 3: Satellite Box & RF Program Source ᕡ Make sure the satellite cable from the wall is connected to your satellite box. ᕢ Connect a Composite A/V cable from the Audio/Video Output jacks on the satellite box to the Audio/Video Input jacks on the DVR. ᕣ Connect the Coaxial RF cable from your antenna or cable source to the Cable/Antenna-RF In jack on the DVR. ᕤ Connect a Composite A/V cable from the Audio/Video Output jacks on the DVR to the Audio/Video Input jacks on the TV. If your TV doesn't have Composite A/V input jacks, connect a Coaxial RF cable from the DVR's RF Out jack to your TV's Antenna/RF In jack. ᕥ Connect the phone cord (see page 8). After you complete Guided Setup, you can connect your DVR to a home network and use a broadband Internet connection instead of a phone line to connect to the TiVo service. See Chapter 7. ᕦ Connect a channel changing cable (see the diagrams to the right). ᕧ Plug in all power cords and turn on your TV. Set your TV to display video from the input jacks you used in step ᕤ. You may have to find the correct TV input setting by pressing the Input or TV/Video button on your TV's remote control until you see the Welcome screen. (For more help, see page 125.) If you used a Coaxial RF cable in step ᕤ, tune your TV to channel 3 or 4, matching the Channel 3/4 switch on the back of the DVR. Once you see the Welcome screen, the final steps are to activate the TiVo service and complete Guided Setup (see Chapter 2). If you want to add a VCR, DVD recorder, or other equipment, see page 20. ᕦ Connect a Channel Changing Cable (See page 5 for help choosing a channel changing cable.) Serial Control cable: Serial Control cable connection 1 Plug one end of the Serial Serial Control cable into the Serial/Data connector on the cable or satellite box. Plug the other end into the Control Out-Serial connector (the upper mini jack) on the back of the DVR. IR Control cable: (a) Plug the purple end of the IR Control cable into the Control Out-IR connector (the lower mini-jack) on the DVR. (b) Locate the IR sensor (see page 6 for help). (c) Mount the IR emitters. Place one emitter on top of the cable/satellite box and the other underneath it. Be sure both emitters stick out about 1.5 inches directly in front of the IR sensor. Use the provided adhesive strips to hold the emitters in place. Cable or Satellite Box c b TiVo DVR ® IR Control cable connection a 15