Humax VA-3210 User Manual - Page 32
Troubleshooting Guide
View all Humax VA-3210 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
Troubleshooting Guide Problem Does not display any LED on the front panel or STB has no power. Solution About STB • Check the main power cable and check that it is plugged into a suitable power outlet. • Check whether STB is in Standby mode. No Picture • Ensure that the STB is switched on (see above). • Check the video output port (RCA/RF) is firmly connected to the TV or VCR. • Check that you have selected the correct channel or Video Output on your TV. • Check the brightness level of the TV. Poor picture quality • See "No Picture" above. • Check the signal level, if this is low then try adjusting the alignment of your dish. No Sound • See "No Picture" above. • Check the volume level of the TV and STB. • Check the Mute status of the TV and STB. Remote Control does not • Point remote control directly towards the STB. operate • Check and replace batteries. No or Bad Signal "No Signal" in manual search On-Screen Error Messages • Check the LNB - replace LNB if necessary. • Check the cable from the LNB. • Check the position of the dish - realign dish if necessary. • If you are using a DiSEqC 1.0 switch, check that you have connected the LNBs to the correct connections on the switch. • Check the "Signal Level" and the "Signal Quality" in the Signal Status menu. Service Search • Check the "Signal Level" and the "Signal Quality" in the Signal Status menu. • Check the LNB - replace LNB if necessary. • Check the cable from the LNB. • Check the position of the dish - realign dish if necessary. • DiSEqC 1.0 Check that you have connected the LNBs to the correct connections on the switch. Check that you have set the connected setting in the Antenna Setting menu. 31