Humax VA-5200C User Manual - Page 23

• Press the button to save, or press the button to exit without saving. • Then Service Searching menu appears again. When you exit from all menus, the first service of the found service list is played. In the bottom of found service picture, network, the information of transponder and the number of found service that the services belong to are displayed. The deleted service by the Red( )button is excepted from counting of the number of services. The deleted service is not included in this number. "Free" applies to the empty space of the memory. It will be used to store future services. Automatic Search Start Frequency In order to set the frequency range to seek, set the frequency which the automatic service serch starts from. End Frequency In order to set the frequency range to seek, set the frequency which the automatic service search ends to. Symbol Rate Set the Symbol Rate of cable signal you want to find. Constellation Select the constellation of the cable signal you want to find. You can select the value of 16, 32, 64, 128, 256-QAM or Auto. Press the button anywhere to start Automatic Search. The picture during searching is as follows. The picture searches with varying Frequency, Symbol Rate and FEC etc. Satellite Name is the name that the user selects to correspond with Antenna Alternative of Antenna Setting. The progress bar(%) appears on bottom of the picture. During the search, services that are found are displayed as follows: 1. Press the button during Automatic Search to stop search. 2. After the search is finished, the appearite message appears. 3. Press the button to return Service Search menu. 22