Humax VA-OTV User Manual - Page 32

Motorised System 3. Initial Satellite Position Search This is required when you first set your receiver up to use DiSEqC 1.2 and sets the positions of all pre-programmed satellites. 1. Make sure your motor is installed correctly with the calibrations adjusted for the region you are situated. (Please consult the user manual for your motor.) 2. Make sure your receiver is set up to use DiSEqC 1.2. (see section 2 above). 3. On the Main Menu, select Service Searching option and press the button, you should now see the Service Searching menu. 4. Highlight the option Antenna Alternative and press the button to display the Satellite Setting menu. 5. Highlight the DiSEqC Command Mode option and use the buttons to change the value to Installer and press the button. 6. Highlight the Motor Control option and use the buttons to change the value to reset and press the button. 7. You will now see a warning message, press the button to continue. All motor positions of the pre-programmed satellites should now be correct. If you have any other make or model of DiSEqC 1.2 motor then you may need to store the satellite positions in yourself (Please refer to the user manual for your motor). 8. Highlight the DiSEqC Command Mode option and use the buttons to change the value to User and press the button. 9. You should now be ready to start storing services for the various satellites (see 5 onwards). 4. Manual Satellite Search The purpose of this is to set the motor position for each satellite manually. This is useful if the satellite you require is not available from the pre-programmed list (see 3 above). To do this, you must access the Satellite Settings menu. Do as follows ; 1. Select Service Searching from the main menu and press the button, to display the Service Searching menu. 2. Select the Manual Search option and press the button, to display the Manual Search menu. Select the relevant Antenna Alternative that you are using for this satellite. 3. Enter the Frequency, Polarisation, Symbol Rate and FEC of a transponder on the satellite you wish to find. This transponder information should be unique to this satellite. 4. Select the Antenna Alternative option and press the button, to display the Satellite Settings menu. 5. Highlight the option DiSEqC Command Mode and using the buttons change this to Installer. 6. Highlight the option Satellite name and use the buttons to select the satellite you want to find, use others if the name of the satellite you want does not appear. 7. When you have selected the satellite you wish to find, go down to the Movement option and again using the buttons to start the motor moving. 31