Humax XD-400 User Manual - Page 83

Error message Possible causes What to do No or bad signal The satellite dish is not pointing at the satellite. Signal is too weak. Satellite dish is too small. Problem with LNB. Wrong antenna setting. Adjust dish alignment. Increase the LNB voltage or connect a signal amplifier. Change to a larger dish. Change the LNB. Set the antenna correctly. The channel is scrambled or not available. The channel has a signal, but no audio or video is provided. The channel has not been deleted by broadcasting company. Confirm if the channel is currently on air. Remove the channel from the channel list and check for new transponder details. The channel is for data broadcasting. Smartcard is not plugged in. Wrong Smartcard is in use. Smartcard is not plugged in correctly. The channel cannot be viewed with the appropriate model that supports data channels. Insert Smartcard. Smartcard is damaged. Insert the appropriate Smartcard for the channel(s) you wish to view. Reinsert Smartcard; ensure that it is inserted correctly. Contact your Smartcard retailer or channel broadcaster for a Smartcard replacement. Audio not available. The channel has a video signal, but no audio is provided. Press the audio button on your remote control to confirm that the channel has audio options. CI-Module not installed. CI-Module is not installed. CI-Module is not inserted correctly. CI-Module is not recognized. Insert CI-Module. Reinsert CI-Module. Insert a different CI-Module to check if your existing module is working. Invalid CI-Module Wrong CI-Module. CI-Module is not inserted correctly. CI-Module is damaged. Insert the correct CI-Module. Remove and reinsert the CI-Module. Replace CI-Module. Short LNB LNB cable is short. LNB is internally short. LNB In port is inserted by alien substance or damaged. eplace LNB Cable. Replace LNB. Remove the alien substance and contact local service center in case damaged has occurred.