Humax iCordHDMiddleEast User Manual - Page 16

Connect one end of the LAN cable to the product and the other end to the LAN router. You can connect the network via the Wi-Fi access point. 1. Plug in the wireless USB dongle to the USB port. (Separately purchased) 2. Set the options for the Wi-Fi. > Network Name (SSID): Select the network name of your Wi-Fi access point from the list. > Security Type (WEP): This product supports WEP 40/128bit ASCII and WEP 40/128bit HEX. The security type of the Wi-Fi and the product shall be set the same. > Password: You must set the password to use the security type. Enter the same password in the Wi-Fi setting menu. 3. After you complete Wi-Fi access point setting, make sure the settings in Installation Wizard or System>Internet Setting>Configure Wi-Fi are the same. ** Note: • We recommend the network connection over a direct LAN. • Make sure the distance between the Wi-Fi access point and the product is not too far away. This may lower the quality of service. • It is recommended to use a wireless USB dongle distributed by HUMAX. Other products may not function or respond. **