Humax iHDR-5200C User Manual - Page 11

Quick Start Guide Connecting the Network ‫ݎ‬Connecting to the LAN; Connect one end of the Ethernet cable to the product and the other end to the LAN router. ‫ݏ‬Connecting to the Wi-Fi (Wireless LAN); (Reserved for future use.) You can connect the network via the Wi-Fi access point or DSL/cable modem. 1. Plug in the wireless USB dongle to the USB port. (Separate purchase required) 2. Set the options for the Wi-Fi. Network Name (SSID): Select the network name of your Wi-Fi access point from the list. Security Type (WEP): This product supports WEP 40/128bit ASCII and WEP 40/128bit HEX. The security type of the Wi-Fi and the product shall be set the same. Password: When using the security type, you must set the password. Enter the same password in the Wi-Fi setting menu. 3. After completing the Wi-Fi access point setting, make sure the settings in Installation Wizard or Settings>System>Network>Configure Wi-Fi are the same. Note: • Make sure the distance between the Wi-Fi access point and the product is not too far away. This may lower the quality of service. • It is recommended to purchase a wireless USB dongle distributed by HUMAX. Other products may not function or respond. Visit the HUMAX website to find the information on purchasing a wireless USB dongle. (http://www.myhumax.nl) WLAN USB Dongle 21 Ethernet Cable LAN Wireless Router Router Note: We recommend the network connection over a direct LAN. 10