Husqvarna 1830HV Owners Manual

Husqvarna 1830HV Manual

Get Husqvarna 1830HV PDF manuals and user guides View all Husqvarna 1830HV manuals
Add to My Manuals
Save this manual to your list of manuals

Husqvarna 1830HV manual content summary:

  • Husqvarna 1830HV | Owners Manual - Page 1
    's Manual 1830HV / 96193007300 532 44 34-17 Gasoline containing up to 10% ethanol (E10) is acceptable for use in this machine. The use of any gasoline exceeding 10% ethanol (E10) will void the product warranty. Please read the owner's manual carefully and make sure you understand the instructions
  • Husqvarna 1830HV | Owners Manual - Page 2
    a foreign object, stop the engine (motor), remove the wire from the spark plug, disconnect the cord on electric motors, thoroughly inspect the snow thrower for any damage, and repair the damage before restarting and operating the snow thrower. 4. If the unit should start to vibrate abnormally, stop
  • Husqvarna 1830HV | Owners Manual - Page 3
    50°F) SAE 5W-30 (below 32°F) Oil Capacity: 38 Ounces (1,12 Liters) Spark Plug: Gap: Champion F6RTC 0.030" (0,762 mm) CUSTOMER RESPONSIBILITIES • Read and observe the safety rules. • Follow a regular schedule in maintaining, caring for and using your snow thrower. • Follow the instructions under
  • Husqvarna 1830HV | Owners Manual - Page 4
    and proper operation of your snow thrower, all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to ensure proper tightness. 2. Cut down all four corners of carton and lay panels flat. 3. Remove the two (2) screws securing the auger housing to the pallet
  • Husqvarna 1830HV | Owners Manual - Page 5
    thrower and making adjustments to the skid plates. UNFOLD UPPER HANDLE 1. Raise upper handle to the operating position and tighten handle knobs securely. Additional carriage bolts, washers and handle knobs are in bag of parts rod is installed on the snow thrower. 1. Remove plastic tie securing
  • Husqvarna 1830HV | Owners Manual - Page 6
    and insert end of rod into hole in auger control bracket. Secure with retainer spring. INSTALL DISCHARGE CHUTE / CHUTE ROTATER HEAD parts bag may be used to install the chute rotater head. 1. Place discharge chute assembly on top of chute base with discharge opening toward front of snow thrower
  • Husqvarna 1830HV | Owners Manual - Page 7
    BRACKET 5/16-18 LOCKNUT FIG. 8 CHUTE DEFLECTOR CONTROL LEVER FIG. 9 CHECK TIRE PRESSURE The tires on your snow thrower were overinflated at the factory for shipping purposes. Correct and equal tire pressure is important for best snow throwing performance. • Reduce tire pressure to 14-17 PSI. 7
  • Husqvarna 1830HV | Owners Manual - Page 8
    snow thrower or in literature supplied with the product. Learn and understand their meaning. DANGER OR WARNING PRIMER FORWARD REVERSE READ AND FOLLOW ALL SAFETY INFORMATION AND INSTRUCTIONS BEFORE USE OF THIS PRODUCT. KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE. IGNITION KEY. INSERT TO START
  • Husqvarna 1830HV | Owners Manual - Page 9
    motion of snow thrower. Electric start button - used for starting the engine. Recoil (auxiliary) starter handle - used for starting the engine. Deflector remote control lever - used to change the distance the snow is thrown. LH and RH turn triggers - used to steer the snow thrower. Primer - pumps
  • Husqvarna 1830HV | Owners Manual - Page 10
    controls before adding fuel or attempting to start the engine. STOPPING TRACTION DRIVE • Release traction drive control lever to stop the forward or reverse movement of the snow thrower. AUGER • Release the auger control lever to stop throwing snow. ENGINE 1. Move ON / OFF switch to "OFF" position
  • Husqvarna 1830HV | Owners Manual - Page 11
    auger/impeller and all moving parts have stopped. Disconnect the spark plug wire and keep the wire away from the spark plug to prevent accidental starting. • Release the auger control lever and shut off the engine forward or reverse movement of the snow thrower. SPEED and DIRECTION are controlled by
  • Husqvarna 1830HV | Owners Manual - Page 12
    CLEARANCE) HEX NUTS AUGER HOUSING SCRAPER BAR SKID PLATE BEFORE STARTING THE ENGINE CHECK ENGINE OIL LEVEL (See Fig. 19) The engine on your snow thrower has been shipped from the factory already filled with oil. 1. Check engine oil with snow thrower on level ground. 2. Remove oil fill cap/dipstick
  • Husqvarna 1830HV | Owners Manual - Page 13
    OPERATION TO START ENGINE • Be sure fuel shut-off valve is in the "OPEN" position. Your snow thrower engine is equipped with both a 120 Volt A.C. electric starter and a recoil starter. The electric starter is equipped with a three-wire power cord and plug and is designed to operate on 120 Volt A.C.
  • Husqvarna 1830HV | Owners Manual - Page 14
    At least once a year, you should replace the spark plug and check belts for wear. A new spark plug will help your engine run better and last longer. • Follow the maintenance schedule in this manual. NOTE: Use only Original Equipment Manufacturer (OEM) parts to service this unit. Failure to do so can
  • Husqvarna 1830HV | Owners Manual - Page 15
    in contact with spark plug. • Keep finished surfaces/wheels free of gasoline, oil, etc. • We do not recommend using a garden hose to clean your snow thrower unless the electrical system, muffler and carburetor are covered to keep water out. Water in engine can result in shortened engine life. 15
  • Husqvarna 1830HV | Owners Manual - Page 16
    your snow thrower. AUGER SHAFT IMPELLER SHAFT 1/4-20 LOCKNUT FIG. 20 TO REMOVE BELT COVER (See Fig. 21) 1. Loosen the two (2) screws securing belt cover to frame. 2. Remove belt cover. • Replace belt cover by installing cover and tightening screws. BELT COVER 4. iCgonnitinoenckt sepyark plug
  • Husqvarna 1830HV | Owners Manual - Page 17
    routing of belts. If auger belt has become dislodged from the pulley (by catching the idler arm bracket while bringing snow thrower together), separate the snow thrower and repeat step 12. Belt must be fully seated in pulley groove when bringing the snow thrower together. 14. Install the two (2) hex
  • Husqvarna 1830HV | Owners Manual - Page 18
    does not operate properly due to suspected carburetor problems, take your snow thrower to a qualified service center. ENGINE SPEED Never tamper with the engine governor, which is factory set for proper engine speed. Overspeeding the engine above the factory high speed setting can be dangerous and
  • Husqvarna 1830HV | Owners Manual - Page 19
    oil. 4. Replace with new spark plug. OTHER • Remove safety ignition key; store it in a safe place. • Do not store gasoline from one season to another. • Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems. • If possible, store your snow thrower
  • Husqvarna 1830HV | Owners Manual - Page 20
    of power 1. Spark plug wire loose. 2. Throwing too much snow. 3. Fuel tank cap is covered with ice or snow. 4. Dirty or clogged muffler. 1. Reconnect spark plug wire. 2. Reduce speed and width of swath. 3. Remove ice and snow on and around fuel tank cap. 4. Clean or replace muffler. Engine idles
  • Husqvarna 1830HV | Owners Manual - Page 21
    &RQVXPHU:KHHOHG3URGXFWV±/LPLWHG:DUUDQW\ +XVTYDUQDZDUUDQWVWRWKHRULJLQDOUHWDLOSXUFKDVHUWKDWWKLV+XVTYDUQDŠSURGXFWLVIUHHIURPGHIHFWVLQPDWHULDORUZRUNPDQVKLS XQGHUQRUPDOXVHDQGPDLQWHQDQFHIURPWKHGDWHRIUHWDLOSXUFKDVHIRUWKHDSSOLFDEOH:DUUDQW\3HULRGVKRZQRQ([KLELW$&
  • Husqvarna 1830HV | Owners Manual - Page 22
    FDOO +XVTYDUQD DW GXULQJ WKH KRXUV RI  $0 WR  30 (DVWHUQ 6WDQGDUG 7LPH RU YLVLW ZZZKXVTYDUQDFRP 6KRXOG\RXUHTXLUH LPLWHG:DUUDQW\\RXPD\FRQWDFWXVDW GXULQJWKH KRXUVRI$0WR30(DVWHUQ6WDQGDUG7LPHRUFRQWDFWXVWKURXJKWKHZHEDWZZZKXVTYDUQD
  • Husqvarna 1830HV | Owners Manual - Page 23
    &RQVXPHU:KHHOHG:DUUDQW\&KDUW ([KLELW$ &RQVXPHU SHUVRQDO &RPPHUFLDO DQ\FRPPHUFLDO 5HQWDO DQ\UHQWDO KRXVHKROGXVHRQO\ SURIHVVLRQDOLQVWLWXWLRQDO XVDJH DULJFXOXWUDORULQFRPHSURGXFLQJ XVHRWKHUWKDQ5HQWDO8VH 3URGXFW&RPSRQHQW 5LGLQJ/DZQ7UDFWRUV )UDPH&KDVVLV
  • Husqvarna 1830HV | Owners Manual - Page 24
    &RQVXPHU:KHHOHG:DUUDQW\&KDUW ([KLELW$ &RQVXPHU SHUVRQDO &RPPHUFLDO DQ\FRPPHUFLDO KRXVHKROGXVHRQO\ SURIHVVLRQDOLQVWLWXWLRQDO DULJFXOXWUDORULQFRPHSURGXFLQJ XVHRWKHUWKDQ5HQWDO8VH 3URGXFW&RPSRQHQW )URQW0RXQWHG'HFN5LGHUV (QJLQH   7UDQVPLVVLRQ 
  • Husqvarna 1830HV | Owners Manual - Page 25
    SERVICE NOTES 25
  • Husqvarna 1830HV | Owners Manual - Page 26
    SERVICE NOTES 26
  • Husqvarna 1830HV | Owners Manual - Page 27
    SERVICE NOTES 27
  • Husqvarna 1830HV | Owners Manual - Page 28
    06/17/2011 TH
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
English
532 44 34-17
Operator’s Manual
1830HV / 96193007300
Gasoline containing up to 10% ethanol (E10) is acceptable for use in this machine.
The use of any gasoline exceeding 10% ethanol (E10) will void the product warranty.
Please read the owner's manual carefully and make sure you
understand the instructions before using the machine.