Husqvarna PZ 54 Owners Manual
Husqvarna PZ 54 Manual
 |
View all Husqvarna PZ 54 manuals
Add to My Manuals
Save this manual to your list of manuals |
Husqvarna PZ 54 manual content summary:
- Husqvarna PZ 54 | Owners Manual - Page 1
INSTALLATION INSTRUCTIONS OCDC Kit - 966 488701 54" and 60" Decks 1. Remove the discharge chute assembly from the mower deck by removing the nuts and bolts as shown in the inset, using the mounting bracket as a guide. Chute mount Trimmed chute P/N 115 258027 R1 09/09/09 Reinforcement plate - Husqvarna PZ 54 | Owners Manual - Page 2
INSTRUCTIONS 5. Bolt the mounting bracket to discharge chute flange with a 5/16-18 x 1 round head square neck bolt and secure with nut. Using the holes in the bracket as a guide plate Pivot guard 8. Locate the gates in the OCDC kit. For 54" decks, use the smaller gate. Use the larger gate for a - Husqvarna PZ 54 | Owners Manual - Page 3
INSTALLATION INSTRUCTIONS Assemble the pivot link to the main link following the illustration. Adjust the front nut so the spring is compressed to a measurement of 15/8"-1¾". Tighten
-
1 -
2 -
3
 |
 |
P/N 115 258027 R1
09/09/09
INSTALLATION INSTRUCTIONS
OCDC Kit - 966 488701
54" and 60" Decks
Remove the discharge chute assembly from the
1.
mower deck by removing the nuts and bolts retaining
the brackets.
Install the chute mount and reinforcement plate from
3.
the kit to the original discharge chute using the
5
/
16
-18
x 1¼ round hea square neck bolts and two
5
/
16
-18 x
1¼ hex head bolts. Secure with nuts.
Trim the discharge chute as shown in the inset, using
4.
the mounting bracket as a guide.
Remove the pivot bracket and bracket reinforcement
2.
from the discharge chute.
NOTE: Save brackets and hardware for reuse when
reverting to side discharge mowing without OCDC.
Bracket
reinforcement
Retaining hardware
Pivot bracket
Chute mount
Reinforcement
plate
Trimmed chute
Discharge chute