Husqvarna ST 324 Owners Manual

Husqvarna ST 324 Manual

Get Husqvarna ST 324 PDF manuals and user guides View all Husqvarna ST 324 manuals
Add to My Manuals
Save this manual to your list of manuals

Husqvarna ST 324 manual content summary:

  • Husqvarna ST 324 | Owners Manual - Page 1
    's Manual ST 324P Gasoline containing up to 10% ethanol (E10) is acceptable for use in this machine. The use of any gasoline exceeding 10% ethanol (E10) will void the product warranty. 115 68 19-27 Rev. 1 Please read the owner's manual carefully and make sure you understand the instructions
  • Husqvarna ST 324 | Owners Manual - Page 2
    harm. Training 1. Read, understand and follow all instructions on the machine and in the manual(s) before operating this unit. Be thoroughly familiar with check immediately for the cause. Vibration is generally a warning of trouble. 5. Stop the engine (motor) whenever you leave the operating
  • Husqvarna ST 324 | Owners Manual - Page 3
    . Should you experience any problem you cannot easily remedy, please contact your nearest authorized service center. We have competent, well-trained technicians and the proper tools to service or repair this unit. Please read and retain this manual. The instructions will enable you to assemble
  • Husqvarna ST 324 | Owners Manual - Page 4
    PARTS PACKED SEPARATELY IN CARTON SAFTEY IGNITION KEY (S) (443059) (1) MULTIWRENCH (180684) (1) WASHER 3/8 (1) LOCKNUT 3/8 (19131316) (73800600) (1) RETAINER SPRINGS (169675) (6) SHEAR BOLTS 1/4-20 x 1-3/4 (585511801) (6) LOCKNUTS 1/4-20 (73800400) (2) FLAT WASHERS UHMW SKID PLATES (2)
  • Husqvarna ST 324 | Owners Manual - Page 5
    ASSEMBLY / PRE-OPERATION Read these instructions and this manual in its entirety before you attempt to assemble or operate your new snow thrower. Reading the entire manual will familiarize you with the unit, which will assist you in assembly, operation and maintenance of the product. Your new snow
  • Husqvarna ST 324 | Owners Manual - Page 6
    ASSEMBLY / PRE-OPERATION INSTALL TRACTION DRIVE CONTROL ROD (See Figs. 3 and 4) The traction drive control rod is installed on the snow thrower. 1. Remove plastic tie securing traction drive control rod to rotator bracket. 2. With top end of rod positioned under left side of control panel, push rod
  • Husqvarna ST 324 | Owners Manual - Page 7
    ASSEMBLY / PRE-OPERATION INSTALL DISCHARGE CHUTE / CHUTE ROTATOR HEAD (See Fig. 7) NOTE: The multi-wrench provided in your parts bag may be used to install the chute rotator head. 1. Place discharge chute assembly on top of chute base with discharge opening toward front of snow thrower. 2. Position
  • Husqvarna ST 324 | Owners Manual - Page 8
    BEFORE USE OF THIS PRODUCT. KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE. DANGER DO NOT PLACE HANDS NEAR BLADES DANGER, KEEP FEET AWAY REMOVE SPARK DANGER PLUG WIRE BEFORE READ OPERATORS MANUAL PERFORMING WATCH FOR THROWN OBJECTS MAINTENANCE OPERATE AT A SAFE DISTANCE FROM OTHER
  • Husqvarna ST 324 | Owners Manual - Page 9
    MUFFLER CHOKE CONTROL THROTTLE CONTROL ON/OFF SWITCH OPERATION POWER CORD GASOLINE PLUG FILLER CAP ELECTRIC START BUTTON AUGER CONTROL LEVER DISCHARGE CHUTE CONTROL LEVER DRIVE SPEED CONTROL LEVER DEFLECTOR REMOTE CONTROL LEVER PRIMER SAFETY IGNITION KEY FUEL SHUT-OFF VALVE CHUTE
  • Husqvarna ST 324 | Owners Manual - Page 10
    OPERATION The operation of any snow thrower can result in foreign objects thrown into the eyes, which can result in severe eye damage. Always wear safety glasses or eye shields while operating your snow thrower or performing any adjustments or repairs. We recommend standard safety glasses or a wide
  • Husqvarna ST 324 | Owners Manual - Page 11
    OPERATION TO THROW SNOW (See Fig. 15) The auger rotation is controlled by the auger control lever located on the right side handle. • Squeeze auger control lever to handle to engage the auger and throw snow. • Release the auger control lever to stop throwing snow. AUGER CONTROL LEVER FIG. 15 USING
  • Husqvarna ST 324 | Owners Manual - Page 12
    until "FULL" mark on dipstick is reached. Do not overfill. • To change engine oil, see "TO CHANGE ENGINE OIL" in the Maintenance section of this manual. ADD GASOLINE (See Fig. 21) • Fill fuel tank to bottom of tank filler neck. Do not over- fill. Use fresh, clean, regular unleaded gasoline with
  • Husqvarna ST 324 | Owners Manual - Page 13
    the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or and carburetor are empty. Use fresh fuel next season. See Storage Instructions for additional information. Never use engine or carburetor cleaner products in the
  • Husqvarna ST 324 | Owners Manual - Page 14
    downwind whenever possible. • Adjust the skid plates to proper height for current snow conditions. See "TO ADJUST SKID PLATES" in this section of this manual. • For extremely heavy snow, reduce the width of snow removal by overlapping previous path and moving slowly. • Keep engine clean and clear of
  • Husqvarna ST 324 | Owners Manual - Page 15
    from the warranty, operator must maintain snow thrower as instructed in this manual. Some adjustments will need to be made periodically to if you should make any of the adjustments described in the Service and Adjustments section of this manual. • At least once a year, you should replace the
  • Husqvarna ST 324 | Owners Manual - Page 16
    the frame with the left wheel removed, will help drain any oil trapped inside the engine. (See "TO REMOVE WHEELS" in the Service and Adjustments section of this manual). 1. Remove safety ignition key and disconnect spark plug wire from spark plug and place wire where it cannot come in contact with
  • Husqvarna ST 324 | Owners Manual - Page 17
    ADJUSTMENTS WARNING: To avoid serious injury, before performing any service or adjustments: 1. Be sure the on/off switch See "TO ADJUST SKID PLATES" and "SCRAPER BAR" in the Operation section of this manual. CHUTE DEFLECTOR The chute deflector, attached to the top of the discharge chute, is provided
  • Husqvarna ST 324 | Owners Manual - Page 18
    should be replaced. It is recommended that the belt(s) be replaced by a service center/department. NOTE: It is recommended that both the auger and traction drive COVER - See "TO REMOVE BELT COVER" in this section of this manual. 4. REMOVE ENGINE PULLEY - Remove bolt, flat washer securing pulley to
  • Husqvarna ST 324 | Owners Manual - Page 19
    ADJUSTER TURN BUCKLE WHEEL FIG. 25 WHEEL HUB ENGINE SEE ENGINE MANUAL. CARBURETOR Your carburetor is not adjustable. Engine performance should not be not operate properly due to suspected carburetor problems, take your snow thrower to a service center/department. ENGINE SPEED Never tamper with
  • Husqvarna ST 324 | Owners Manual - Page 20
    REPLACE BELTS" in the Service and Adjustments section of this manual). 3. Lubricate as shown in the Maintenance section of this manual. 4. Be sure your can starts to rust. Rust and/or dirt in your gasoline will cause problems. • If possible, store your snow thrower indoors and cover it to protect
  • Husqvarna ST 324 | Owners Manual - Page 21
    TROUBLESHOOTING See appropriate section in manual unless directed to a service center/department. PROBLEM CAUSE CORRECTION Does not to FULL position. 6. Primer not depressed. 6. Prime as instructed in the Operation section of this manual. 7. Engine is flooded. 7. Wait a few minutes before
  • Husqvarna ST 324 | Owners Manual - Page 22
    , such as throttle cable, belt guides adjustments; and c. Preventative maintenance as outlined in the operator's manual. In addition, you must cease using the product immediately upon any failure or damage. The product should be taken to an authorized Husqvarna servicing dealer prior to any further
  • Husqvarna ST 324 | Owners Manual - Page 23
    50:1 and is listed in the Husqvarna oil label and covered in your operator's manual. (h) Use of ether or any use of product, after initial operational problem or failure occurs. 9. Reinforced ultraviolet light. HOW TO OBTAIN SERVICE 10. Authorized Husqvarna Servicing Dealer/Center. In order to
  • Husqvarna ST 324 | Owners Manual - Page 24
    other than Rental Use) Riding Lawn Tractors: Frame, Chassis, Front Axle 5 Years No Warranty Engine* * * Transmission (if made by Husqvarna/Peerless) 3 Years No Warranty Transmission (if third party)** * * * * XLS Models only - stamped deck shell. Armor Protected Limited Warranty 10
  • Husqvarna ST 324 | Owners Manual - Page 25
    Warranty No Warranty Parts & Accessories (if replaced in Warranty Service) Replacement parts and/or accessories provided under this Limited Warranty network. EZ - One (1) Year Commercial warranty, parts & labor, with Husqvarna. Two (2) Year Consumer warranty, parts & labor, with Hydro-Gear
  • Husqvarna ST 324 | Owners Manual - Page 26
    SERVICE NOTES 26
  • Husqvarna ST 324 | Owners Manual - Page 27
    SERVICE NOTES 27
  • Husqvarna ST 324 | Owners Manual - Page 28
    06/17/2014 AP
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
English
115 68 19-27
Rev. 1
Operator’s Manual
ST 324P
Gasoline containing up to 10% ethanol (E10) is acceptable for use in this machine.
The use of any gasoline exceeding 10% ethanol (E10) will void the product warranty.
Please read the owner's manual carefully and make sure you
understand the instructions before using the machine.