Intermec CN50 Multidock Mounting Bracket Instructions
Intermec CN50 Manual
 |
View all Intermec CN50 manuals
Add to My Manuals
Save this manual to your list of manuals |
Intermec CN50 manual content summary:
- Intermec CN50 | Multidock Mounting Bracket Instructions - Page 1
Multidock Mounting Bracket Instructions Use these instructions to securely mount the following docks to a wall: • 700 Series multidock • CK3 multidock • CN3 multidock • CN4 multidock • CN50 multidock • DX2 Dual Dock • DX4 Quad Dock The multidock wall mount kit (P/N 203-641-xxx) contains these items: - Intermec CN50 | Multidock Mounting Bracket Instructions - Page 2
To attach the 700 Series multidock to the mounting bracket 1 Remove the four outside screws, two on each side, from the bottom of the multidock. 2 Position the mounting brackets over the screw holes. 3 Attach the two brackets to the multidock with the four thumbscrews provided. Note: Do not use - Intermec CN50 | Multidock Mounting Bracket Instructions - Page 3
To attach the CK3, CN3, CN4, CN50, DX2, or DX4 multidock to the mounting bracket 1 Position the mounting brackets over the screw holes. 2 Attach the two brackets to the multidock with the four thumbscrews provided. Note: Do not use tools, or overtighten the thumbscrews. Attaching the Mounting - Intermec CN50 | Multidock Mounting Bracket Instructions - Page 4
the mounting brackets to the wall with the hardware you provided. Use two fasteners in each bracket. Fastener (4 places) Multidock Mounting Bracket Instructions *931-035-003* P/N 931-035-003 Worldwide Headquarters 6001 36th Avenue West Everett, Washington 98203 U.S.A. tel 425.348.2600 fax 425.355
-
1 -
2 -
3 -
4
 |
 |
Use these instructions to securely mount the following docks to a wall:
•
700 Series multidock
•
CK3 multidock
•
CN3 multidock
•
CN4 multidock
•
CN50 multidock
•
DX2 Dual Dock
•
DX4 Quad Dock
The multidock wall mount kit (P/N 203-641-xxx) contains these items:
Items not provided:
•
Hardware to attach the mounting brackets to the wall. You will need four
1/4-inch (6 mm) or larger hardware (lag screw or concrete fastener) to
attach the mounting bracket to a wall.
On framed walls, it is best to drive lag screws directly into studs whenever
possible. If this is not possible, it may be necessary to install scab studs or
plywood that is 5/8-inch (16 mm) thick or greater, for reinforcement.
Note:
When installing several multidocks across a wall, be sure to
allow clearance between them for the power cables.
Two mounting brackets
Four thumbscrews
Documentation
Multidock Mounting Bracket Instructions