Intermec CS40 CS40 Battery (Model 1005AB02) Instructions
Intermec CS40 Manual
 |
View all Intermec CS40 manuals
Add to My Manuals
Save this manual to your list of manuals |
Intermec CS40 manual content summary:
- Intermec CS40 | CS40 Battery (Model 1005AB02) Instructions - Page 1
your Intermec Technologies Service Center for recycling or disposal information. Note: In the U.S.A., the EPA does not consider spent Li-ion batteries as hazardous waste. 1005AB02 CS40 Battery Instructions You need to fully charge the battery before using it in your CS40 Mobile Computer. You - Intermec CS40 | CS40 Battery (Model 1005AB02) Instructions - Page 2
Keep away from children. Use only Intermec charger Model 9005AX01 and P/N 203-936-xxx. Use of incorrect charger may present a risk of fire or explosion. CONTAINS LITHIUM-ION BATTERY. WASTE BATTERY MUST PROMPTLY BE RECYCLED OR DISPOSED OF PROPERLY. SEE INSTRUCTIONS. Vorsicht: Dieser Akkusatz kann sich
-
1 -
2
 |
 |
1005AB02
CS40 Battery Instructions
You need to fully charge the battery before using it in your CS40
Mobile Computer. You can charge batteries after a partial discharge
without affecting the original battery capacity.
A fully discharged
battery charges in approximately 6 hours.
You can charge the battery installed in a CS40 with these Intermec-
approved battery charging accessories:
CS40 Universal Cell Phone Charger (P/N 203-936-xxx)
CS40 Vehicle Power Adapter (Model 9005AX01)
(P/N 852-072-xxx)
Use only these charging accessories. For more information, see the
charging accessory instructions available in the accessory shipping box
or from the Intermec web site at
www.intermec.com
.
For information about additional charging accessories as they become
available, contact your local Intermec representative.
Specifications
Design and specifications are subject to change without notice.
Physical Specifications
Product:
Intermec Li-ion battery (Model 1005AB02)
Dimensions:
60.5 x 52.4 x 19.5 mm (2.4 x 1.1 x 0.8 in)
Weight:
71.0 g (2.5 oz)
Capacity and Output Specifications
Maximum output:
x
4.2 V
Nominal output:
x
3.7 V
Capacity:
2860 mAh, 10.6 Wh
Temperature and Humidity Specifications
Operating temperature:
-20 °C to 60 °C (-4 °F to 140 °F)
Charging temperature:
0 °C to 40 °C (32 °F to 104 °F)
Storage temperature:
-20 °C to 50 °C (-4 °F to 122 °F)
Relative humidity:
5% to 95% non-condensing
Charge the battery before use.
Do not short circuit the battery, and keep it away from
metallic items.
Do not drop the battery or apply mechanical shocks or pressure
to it.
Discarded batteries may create a safety hazard. Before disposal,
cover the battery connector with electrical insulating tape.
Do not disassemble or dispose of in fire.
Do not store the battery at temperatures above 70°C (158°F),
such as inside a car on a hot day or in direct sunlight, as this may
damage the battery.
Do not immerse the battery in water or get the battery wet.
Do not solder directly to the battery contacts.
Use the Intermec battery Model 1005AB01 only with a CS40.
Use of this battery in other devices could result in damage to the
device or battery.
For maximum battery life, the temperature range for charging
batteries is 5°C to 30°C (41°F to 86°F).
Worldwide Headquarters
6001 36th Avenue West
Everett, Washington 98203
U.S.A.
tel
425.348.2600
fax 425.355.9551
www.intermec.com
© 2013 Intermec Technologies
Corporation. All rights reserved.
1005AB02 CS40 Battery Instructions
*943-397-001*
P/N 943-397-001
When the battery reaches the end of its useful life, the spent
battery should be disposed of by a qualified recycler or
hazardous materials handler. Do not mix this battery with
the solid waste stream. Contact your Intermec Technologies
Service Center for recycling or disposal information.
Li-ion
Li-ion
廢電池請回收
Note: In the U.S.A., the EPA does not consider spent Li-ion batteries
as hazardous waste.
Proper Disposal of Waste Batteries
Some of the substances necessary for the proper functioning of
batteries are considered harmful to the environment and to human
health. It is therefore important that those substances be kept out of
the environment.
You play an important role in the protection of the environment:
1.
Keep all waste batteries out of unsorted trash.
2.
Dispose of all waste batteries in separate collection for
treatment and recycling.
Please contact Intermec for the collection option(s) available in your
location.
Marking of the battery:
1.
The wheeled-bin symbol indicates the requirement for separate
collection of the battery.
2.
Two letters shown underneath the wheeled bin indicate the
presence of a certain substance:
a.
Hg means Mercury is present
b.
Cd means Cadmium is present
c.
Pb means Lead is present
3.
The Moebius loop (chasing arrows) indicates that the battery
is recyclable.