Intermec IP30 IP30 (900 MHz) Compliance Insert

Intermec IP30 Manual

Get Intermec IP30 PDF manuals and user guides View all Intermec IP30 manuals
Add to My Manuals
Save this manual to your list of manuals

Intermec IP30 manual content summary:

  • Intermec IP30 | IP30 (900 MHz) Compliance Insert - Page 1
    radio frequency (RF) radiation. Use of antennas and accessories not authorized may void the compliance of this product and may result in RF exposures beyond the limits established for this equipment. When installing and using the Intermec IP30 RFID reader a 23-cm (9-inch) passing distance must be
  • Intermec IP30 | IP30 (900 MHz) Compliance Insert - Page 2
    Intermec Modelo AB3. No hay piezas a las cuales pueda dar servicio el usuario. Cárguela sólo con los modelos Intermec usar el lector Intermec IP30 RFID, debe mantenerse batterie Intermec modèle AB3. Il ne contient aucune pièce réparable par l'utilisateur. Ne charger qu'avec les dispositifs Intermec
  • Intermec IP30 | IP30 (900 MHz) Compliance Insert - Page 3
    cet appareil et peut causer une exposition aux RF au-del des limites établies pour cet équipement Lorsque vous installez et utilisez le lecteur d'IDRF IP30 Intermec, une distance de passage de 23 cm doit être respectée depuis le corps ou la tête de l'utilisateur ou des personnes à proximité et
  • Intermec IP30 | IP30 (900 MHz) Compliance Insert - Page 4
    -102 CENELEC: European Committee for Electrotechnical Standardization RF Intermec IP30 RFID IP30 23 cm KN 22 B Para Usuários do e fonte de alimentação Cuidado: Para uso apenas com a bateria modelo AB3 da Intermec. Este equipamento não contém peças que possam ser reparadas pelo
  • Intermec IP30 | IP30 (900 MHz) Compliance Insert - Page 5
    e usar o leitor Intermec IP30 RFID, deve-se manter uma distância de passagem de 23 cm entre qualquer parte do corpo ou a cabeça do usuário, ou das pessoas nas proximidades, e a antena do IP30. A antena não deve ser tocada quando o transmissor estiver em uso. Modelo: IP30
  • Intermec IP30 | IP30 (900 MHz) Compliance Insert - Page 6
    Intermec IP30 RFID IP30 23 厘米 （9 Intermec Technologies Corporation Intermec Technologies Corporation Intermec AB3 Intermec AC6 型和 AC7 100 ° C Intermec Technologies Li-ion Li-ion SAR ICNIRP)、IEEE C95.1 OET) Bulletin 65 RSS-102 CENELEC RF RF Intermec IP30
  • Intermec IP30 | IP30 (900 MHz) Compliance Insert - Page 7
    7
  • Intermec IP30 | IP30 (900 MHz) Compliance Insert - Page 8
    Worldwide Headquarters 6001 36th Avenue West Everett, Washington 98203 U.S.A. tel 425.348.2600 fax 425.355.9551 www.intermec.com © 2012 Intermec Technologies Corporation. All rights reserved. IP30 (900 MHz) Compliance Insert *933-135-004* P/N 933-135-004, Revision D
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
1
IP30 (900 MHz) Compliance Insert
For Users in English-Speaking Regions
Users of this product are cautioned to use accessories and peripherals approved by Intermec Technologies Corporation. The use of accessories
other than those recommended, or changes to this product that are not approved by Intermec Technologies Corporation, may void the
compliance of this product and may result in the loss of the user’s authority to operate the equipment.
Battery, Charger, and Power Supply Information
Battery Recycling Information
Radiation Exposure Statement
Radio Wave Exposure and Specific Absorption Rate (SAR) Information
Use of antennas and accessories not authorized may void the compliance of this product and may result in RF exposures beyond the limits
established for this equipment.
When installing and using the Intermec IP30 RFID reader a 23-cm (9-inch) passing distance must be maintained from the body or head of the
user or nearby persons and the IP30 antenna. The antenna must not be touched during transmitter operation.
U.S.A. and Canada
Digital Emissions Compliance
This device complies with part 15 of the FCC Rules and with Industry Canada license-exempt RSS standards. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received,
including interference that can cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
•
Reorient or relocate the radio or television receiving antenna.
•
Increase the separation between the computer equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the radio or television receiver is connected.
•
Consult the dealer or an experienced radio television technician for help.
Canadian Digital Apparatus Compliance
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations ICES-3.
Caution: This marking indicates that the user should read all included documentation before use.
Caution: For use with Intermec battery pack Model AB3 only. No user-serviceable parts.
Charge only in or with Intermec Models AC6 and AC7. Use of incorrect charger may present a risk of fire or explosion. Promptly
dispose of used battery pack according to the instruction
Caution: The battery pack used with this product may ignite, create a chemical burn hazard, explode, or release toxic materials if
mistreated. Do not incinerate, disassemble, or heat above 100 °C (212 °F). Do not short circuit; may cause burns. Keep away from
children.
Li-ion
Li-ion
This product contains or uses a lithium-ion (Li-ion) main battery. When the battery reaches the end of its useful life, the spent
battery should be disposed of by a qualified recycler or hazardous materials handler. Do not mix this battery with the solid
waste stream. Contact your Intermec Technologies Service Center for recycling or disposal information.
Warning: This equipment complies with International Commission on Non-Ionizing Radiation Protection (ICNIRP), IEEE C95.1,
Federal Communications Commission Office of Engineering and Technology (OET) Bulletin 65, Canada RSS-102, and European
Committee for Electrotechnical Standardization (CENELEC) limits for exposure to radio frequency (RF) radiation.
R31300
Complies with
IDA Standards
DA 102905
XXXXXXXX