Intermec IV7 IV7 Vehicle-Mount Reader Data Cable Kit Instructions
Intermec IV7 Manual
View all Intermec IV7 manuals
Add to My Manuals
Save this manual to your list of manuals |
Intermec IV7 manual content summary:
- Intermec IV7 | IV7 Vehicle-Mount Reader Data Cable Kit Instructions - Page 1
you assemble the data cable, you need to choose a mounting location for the IV7 on the vehicle. For more information, see the IV7 Vehicle-Mount Reader Instructions. This kit (P/N 203-776-001 or 203-776-002) includes these items: • Data cable with straight connector (P/N 236-086-001) or right-angle - Intermec IV7 | IV7 Vehicle-Mount Reader Data Cable Kit Instructions - Page 2
have determined where the IV7 will be mounted on the vehicle, you can begin assembling the data cable. To assemble the data cable 1 Strip the sheath from the unterminated end of the cable as needed. If necessary, be sure to leave enough room for strain relief. 2 Install connectors on the cable. Use - Intermec IV7 | IV7 Vehicle-Mount Reader Data Cable Kit Instructions - Page 3
Output 1 19 Blue/Red GP Output 2 20 Red/Green GP Output 3 Installing the Data Cable After you assemble the data cable, install it on the vehicle as described in the IV7 instructions. For more information on safely installing the cable, see the next section. - Intermec IV7 | IV7 Vehicle-Mount Reader Data Cable Kit Instructions - Page 4
load back rest assembly. Worldwide Headquarters 6001 36th Avenue West Everett, Washington 98203 U.S.A. tel 425.348.2600 fax 425.355.9551 www.intermec.com © 2010 Intermec Technologies Corporation. All rights reserved. IV7 Vehicle-Mount Reader Data Cable Instructions *943-067-003* P/N 943-067-003
Use this cable to connect the IV7 Vehicle-Mount Reader to:
•
the serial port on a PC.
•
general purpose input/output (GPIO) devices such as motion sensors.
These instructions explain how to assemble the data cable and include
guidelines for installing the cable on the vehicle.
This kit (P/N 203-776-001 or 203-776-002) includes these items:
•
Data cable with straight connector (P/N 236-086-001) or right-angle
connector (P/N 236-126-001), 3.66 m (12 ft)
•
Heatshrink tubing
•
Twenty-eight crimp connectors (P/N 809-084-001)
•
Four 2KΩ, 1-watt resistors
Required Tools
To assemble the data cable, you need:
•
wire cutters and a wire stripper.
•
a crimping tool.
•
a heat gun.
IV
7
Note:
Before you assemble the data cable, you need to choose a
mounting location for the IV7 on the vehicle. For more information,
see the
IV7 Vehicle-Mount Reader Instructions
.
Note:
You may need to provide your own resistors to match your
installation requirements. For more information, see “Assembling
the Data Cable.”
Vehicle-Mount Reader Data Cable Instructions