Intermec IV7 IV7 Vehicle-Mount Reader DC Power Cable Kit Instructions

Intermec IV7 Manual

Get Intermec IV7 PDF manuals and user guides View all Intermec IV7 manuals
Add to My Manuals
Save this manual to your list of manuals

Intermec IV7 manual content summary:

  • 1
  • 2
IV7 Vehicle-Mount Reader DC Power Cable Kit Instructions
*943-068-001*
P/N 943-068-001
Instructions
IV7 Vehicle-Mount Reader DC Power Cable Kit
Use this cable to connect the IV7 Vehicle-Mount Reader to a DC power source
such as a vehicle electrical supply. These instructions explain how to assemble
the power cable and include guidelines for installing the cable on the vehicle.
Note:
These instructions are intended for authorized Intermec
personnel only.
This kit includes these items:
•
Power cable, 12 ft (P/N 236-099-001, or 236-087-001 with right-angle
connector)
•
Fuse holder (P/N 315-075-003)
•
Fuse, 20A/250V (P/N 315-074-003)
•
Heatshrink tubing, 1/8-in x 6 in (P/N 321-649-003)
•
Heatshrink tubing, 3/8-in x 6 in (P/N 321-649-006)
•
Three terminal lugs (P/N 809-083-027)
•
Twelve cable ties (P/N 808-002-000)
• Twelve
cable clips (P/N 808-011-001)
Cable Safety Guidelines
In addition to the power cable, the IV7 requires serial and antenna cables to
connect it to your vehicle-mounted RFID system. As you install the cables,
follow these safety guidelines:
•
Make sure that the cable routing does not interfere with other equipment or
vehicle controls.
•
Keep cables as short as practical and route all cables to minimize exposure to
damage.
•
Make sure the cables will not be pinched or rubbed by moving parts on the
vehicle. You may need to sheath the cable to prevent it from being pinched.
•
Secure the cables every 15 cm (6 in) throughout the length of the cable
run. Use the included cable ties and cable tie clips, or use other hardware
appropriate for the installation.
•
Use a snap-in bushing if the cables pass through a firewall or other sheet
metal.
Note:
Most vehicle manufacturers offer pulley kits for installation of
wiring with risers. Intermec recommends using these manufacturer-
specific kits with any installation of the IV7 on a forklift back rest
assembly.
Before installing this equipment, contact the vehicle manufacturer
to correctly identify the appropriate power connections for this
equipment.
Electrical line filters may be required for reliable operation of the
IV7.
Worldwide Headquarters
6001 36th Avenue West
Everett, Washington
98203
U.S.A.
tel
425.348.2600
fax
425.355.9551
www.intermec.com
©
2006 Intermec Technologies
Corporation. All rights reserved.