Intermec PB50 Printer Cart Dock Instructions
Intermec PB50 Manual
 |
View all Intermec PB50 manuals
Add to My Manuals
Save this manual to your list of manuals |
Intermec PB50 manual content summary:
- Intermec PB50 | Printer Cart Dock Instructions - Page 1
-129-001) to easily attach the PB50 or PB51 printer to a movable cart. You can also use the cart dock to set the printer on a flat surface. The cart dock kit contains these parts: • Cart dock accessory • Four self-tapping screws • Four bolts and nuts • This instruction sheet Note: You must have the - Intermec PB50 | Printer Cart Dock Instructions - Page 2
the cart dock is firmly held in place. 4 Insert the remaining two screws in the other holes on the cart dock and tighten. 5 Install the printer onto the cart dock by lifting up on the belt clip and sliding it over the cart dock as shown below. You are now ready - Intermec PB50 | Printer Cart Dock Instructions - Page 3
To load fanfold media with the cart dock 1 Feed the media up through the slot in the cart and feed it through the slot in the back of the printer. 2 Pull enough media through the slot so that it feeds out about 3 inches (7.62 cm) from the printer. - Intermec PB50 | Printer Cart Dock Instructions - Page 4
are now ready to print using the cart dock and fanfold media. Printer Cart Dock Instructions *943-129-002* P/N 943-129-002 Worldwide Headquarters 6001 36th Avenue West Everett, Washington 98203 U.S.A. tel 425.348.2600 fax 425.355.9551 www.intermec.com © 2009 Intermec Technologies Corporation. All
-
1 -
2 -
3 -
4
 |
 |
Use the cart dock (P/N 943-129-001) to easily attach the PB50 or PB51 printer to a
movable cart. You can also use the cart dock to set the printer on a flat surface. The
cart dock kit contains these parts:
•
Cart dock accessory
•
Four self-tapping screws
•
Four bolts and nuts
•
This instruction sheet
If you are going to use fanfold media with the printer and cart dock, you need to cut
a slot in the cart for the media to feed through before you install the cart dock.
To install the cart dock on a cart
1
Using the cart dock as a template, mark the two adjustable drill holes on your
mounting surface.
Printer Cart Dock Instructions
Note:
You must have the belt clip installed on the printer to use the cart
dock. The belt clip (P/N 825-191-001) secures the printer to the cart dock
accessory.