Intermec PD41 EasyCoder PD4/PD41/PD42 Thermal Printhead (200/300dpi) Installat
Intermec PD41 Manual
View all Intermec PD41 manuals
Add to My Manuals
Save this manual to your list of manuals |
Intermec PD41 manual content summary:
- Intermec PD41 | EasyCoder PD4/PD41/PD42 Thermal Printhead (200/300dpi) Installat - Page 1
PD4/PD41/PD42 Thermal Printhead (200/300 dpi) Installation Instructions These instructions tell you how to install a 200 dpi or 300 dpi thermal printhead in an EasyCoder PD4/PD41/PD42 printer. The kit contains the following: • 200 dpi or 300 dpi thermal printhead • Printhead adapter printed circuit - Intermec PD41 | EasyCoder PD4/PD41/PD42 Thermal Printhead (200/300dpi) Installat - Page 2
2 Open the side door of the printer. 3 Raise the printhead by pulling out the printhead lever and turning it counterclockwise a quarter of a turn. 4 Remove any thermal transfer ribbon. 5 Remove the old printhead by pulling it out toward the front of the printer. Steps 6-9 describe how to replace the - Intermec PD41 | EasyCoder PD4/PD41/PD42 Thermal Printhead (200/300dpi) Installat - Page 3
adapter PCB. 7 Use an appropriate tool, for example a slotted screwdriver, to carefully pry the printhead cable connector loose from the adapter PCB. 8 Remove the two screws that attach the adapter PCB to the printer. Remove the adapter PCB. 9 Attach the new adapter PCB with the two screws removed - Intermec PD41 | EasyCoder PD4/PD41/PD42 Thermal Printhead (200/300dpi) Installat - Page 4
the printer on. Worldwide Headquarters 6001 36th Avenue West Everett, Washington 98203 U.S.A. tel 425.348.2600 fax 425.355.9551 www.intermec.com © 2007 Intermec Technologies Corporation. All rights reserved. EasyCoder PD4/PD41/PD42 Thermal Printhead (200/300dpi) Installation Instructions *1-960658
EasyCoder
®
PD4/PD41/PD42
Thermal Printhead (200/300 dpi) Installation Instructions
These instructions tell you how to install a 200 dpi or 300 dpi thermal
printhead in an EasyCoder PD4/PD41/PD42 printer. The kit contains the
following:
•
200 dpi or 300 dpi thermal printhead
•
Printhead adapter printed circuit board (PCB)
Required Tools
To install the interface board in your printer, you need these tools:
•
Screwdriver, slotted
•
Screwdriver, Phillips (with magnetic tip)
Installing the Thermal Printhead and the Adapter PCB
Before you begin installation, please acknowledge the following important
safety notes:
Make sure the printer has been turned off and
disconnected from the power supply before you
start installation.
Stellen Sie sicher, dass der Drucker abgeschaltet
und von der Stromversorgung abgetrennt wurde,
bevor Sie mit der Installation beginnen.
Take precautions against electrostatic discharge, for
example, by wearing grounded wrist straps.