Intermec PD42 Cutter for PD41/PD42 Installation Instructions
Intermec PD42 Manual
 |
View all Intermec PD42 manuals
Add to My Manuals
Save this manual to your list of manuals |
Intermec PD42 manual content summary:
- Intermec PD42 | Cutter for PD41/PD42 Installation Instructions - Page 1
Installation Instructions Cutter Kit for the EasyCoder® PD41 and PD42 Printers - Intermec PD42 | Cutter for PD41/PD42 Installation Instructions - Page 2
in this document are subject to change without prior notice and do not represent a commitment on the part of Intermec Technologies Corporation. © 2005-2007 by Intermec Technologies Corporation. All rights reserved. The word Intermec, the Intermec logo, Norand, ArciTech, Beverage Routebook, CrossBar - Intermec PD42 | Cutter for PD41/PD42 Installation Instructions - Page 3
your cutter kit and check that all parts depicted below are included. If not, contact your Intermec sales representative. Cutter Mechanism Two screws Two cable clips Cutter cover Cutter spring Two screws (for plastic) 2 Make sure the printer is turned off and disconnected from the power - Intermec PD42 | Cutter for PD41/PD42 Installation Instructions - Page 4
3 Open the side door and remove the tear bar, held by two Phillips screws. 4 Attach the cutter mechanism to the printer using the two Phillips screws included in the kit. EasyCoder PD41/PD42 Cutter Kit Installation Instructions - Intermec PD42 | Cutter for PD41/PD42 Installation Instructions - Page 5
cutter spring to the cover (1). Hook the cutter cover onto the cutter mechanism and lock the cover with the screw at the bottom (2). 1 2 EasyCoder PD41/PD42 Cutter Kit Installation Instructions - Intermec PD42 | Cutter for PD41/PD42 Installation Instructions - Page 6
PD42 printer 1 Turn the printer on. 2 Press Setup ( ). 3 Navigate to Configuration > Cutter > Enable. 4 Press Acknowledge ( ). 5 Press Setup again to exit setup listed below. Please refer to the IPL Programmer's Reference Manual (P/N 066396-xxx) for more information. IPL Cutter Commands Command - Intermec PD42 | Cutter for PD41/PD42 Installation Instructions - Page 7
the printer, follow the instructions provided in the printer's user's guide. The cutter is primarily intended to cut paper-based media in the form of continuous stock. To obtain optimal use of the cutter, make sure your media corresponds to the specification below. Recommended minimum label/paper - Intermec PD42 | Cutter for PD41/PD42 Installation Instructions - Page 8
Intermec Technologies Corporation Worldwide Headquarters 6001 36th Avenue West Everett, WA 98203 U.S.A. tel 425.348.2600 fax 425.355.9551 www.intermec.com EasyCoder PD41/PD42 Cutter Kit Installation Instructions *1-960657-01* P/N 1-960657-01
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
 |
 |
Installation
Instructions
Cutter Kit
for the EasyCoder®
PD41 and PD42 Printers