Intermec PM4i PM4i Power Supply Unit Installation Instructions
Intermec PM4i Manual
 |
View all Intermec PM4i manuals
Add to My Manuals
Save this manual to your list of manuals |
Intermec PM4i manual content summary:
- Intermec PM4i | PM4i Power Supply Unit Installation Instructions - Page 1
PM4i printer. The PSU kit ships with these items: • Power supply unit (P/N 1-971131-003) • This installation instruction sheet To install the power supply unit, you need: • T20 Torx screwdriver This installation procedure must only be performed by an authorized Intermec service technician. Intermec - Intermec PM4i | PM4i Power Supply Unit Installation Instructions - Page 2
3 Remove the four T20 Torx screws from the bottom of the printer and then set the printer back upright. Screw (4 places) 4 Open the media cover and remove the four T20 Torx screws that attach the electronics and front cover to the printer. Screw (4 places) - Intermec PM4i | PM4i Power Supply Unit Installation Instructions - Page 3
and front cover door away from the printer and carefully disconnect the console cable from the CPU board. 6 Disconnect all of the cables from the CPU board. 7 Remove the four T20 Torx screws and the standoff that attach the CPU board to the power supply unit and lift it away from the - Intermec PM4i | PM4i Power Supply Unit Installation Instructions - Page 4
you replace the power supply unit. PM4i Power Supply Unit Installation Instructions *931-067-001* P/N 931-067-001 Worldwide Headquarters 6001 36th Avenue West Everett, Washington 98203 U.S.A. tel 425.348.2600 fax 425.355.9551 www.intermec.com © 2009 Intermec Technologies Corporation. All rights
-
1 -
2 -
3 -
4
 |
 |
Use these installation instructions to replace the power supply unit (PSU) on
the PM4i printer. The PSU kit ships with these items:
•
Power supply unit (P/N 1-971131-003)
•
This installation instruction sheet
To install the power supply unit, you need:
•
T20 Torx screwdriver
To install the power supply unit
1
Turn off the printer power and remove the power cord.
2
Lay the printer on its left cover (the electronics and front cover).
PM
4i
This installation procedure must only be performed by an
authorized Intermec service technician. Intermec assumes no
responsibility for personal injury or damage to the
equipment if the installation is performed by an
unauthorized person.
The electrical components in the printer are susceptible to
damage from electrostatic discharge (ESD). You must
follow standard ESD guidelines to avoid damaging the
equipment you are servicing.
Power Supply Unit Installation Instructions