Intermec SF51 SF51 Battery Instructions

SF

51

Battery (Model 074211) Instructions

SF51 Battery (Model 074211) Instructions

*074650-003*

P/N 074650-003

Worldwide Headquarters

6001 36th Avenue West

Everett, Washington 98203

U.S.A.

tel

425.348.2600

fax 425.355.9551

www.intermec.com

© 2009 Intermec Technologies

Corporation. All rights reserved.

Screw (3 places)

3

Place your finger on the foam so the PCB does not bend when you

disconnect the battery cable. Disconnect the battery cable.

Battery

cable

Place finger here to

hold PCB in place

Battery

LED connector

4

Remove the battery.

5

Install the new battery cable.

6

Place the battery in the compartment in the SF51 bottom case.

7

Carefully close the top and bottom cases. Make sure the cables are

not pinched between the two cases.

8

Install the three screws in the bottom case and tighten them to

0.34 Nm (3 in-lb).

Important Recommendations

Charge the battery before use.

y

See “Charging the Battery” for approved charging methods. Use of

y

this

battery in other devices could result in damage to the device or

battery.

The temperature range for charging batteries is 0°C to 35°C (32°F to

y

95°F). Do not charge battery packs outside this range. For maximum

battery life, charge batteries at 23°C (73°F).

Do not store the battery at temperatures above 60°C (140°F), such

y

as inside a car on a hot day or in direct sunlight, as this may damage

the battery.

Battery usage by children should be supervised

y

.

Do not disassemble or open, crush, bend or deform, puncture, shred,

y

or

burn.

Do not modify the battery or attempt to insert foreign objects into the

y

battery.

Do not solder directly to the battery contacts.

y

Do not immerse the battery in water.

y

Do not short circuit the battery. Keep the battery connector away

y

from metallic items.

Do not apply mechanical shocks or pressure to the battery.

y

Avoid dropping the battery or the SF51. If you suspect that the battery

y

or SF51 is damaged, send it to an Intermec service center for

inspection.

Replace battery only with another Model 074211 battery. This battery

y

has been tested in accordance with applicable safety standards.

Contact your Intermec sales representative or distributor if this

battery is no longer available.

Discarded batteries may create a safety hazard. Before disposal,

y

cover the battery connector with electrical insulating tape.

Charging the Battery

You need to fully charge the battery before using it in your SF51.

Batteries can be charged after a partial discharge without affecting

the original battery capacity. A fully discharged battery charges in

approximately 3 hours.

You can charge the battery with one of these accessories:

SF51 1-Bay Charger (Model 074645)

y

SF51 4-Bay Charger (Model 074646)

y

Replacing the Battery

Warning: Opening the SF51 will void the warranty and

may cause damage to internal components.

Integrated circuits on printed circuit boards (PCBs) in this

equipment are sensitive to damage by electrostatic discharge

(ESD). Prevent ESD by always wearing skin contact ground

straps firmly attached to the equipment metal base assembly

when working inside of the equipment housing. Failure to

comply may result in damage to PCB components.

1

Remove the three screws from the SF51 bottom case.

2

Slowly open, but do not entirely separate, the top and bottom cases.

Leave the LED connector attached to the PCB.

Capacity and Output Specifications

Maximum output:

x

4.1 V

Mean output:

x

3.7 V

Capacity:

2400 MAh (8.9 Wh)

Intermec SF51 SF51 Battery Instructions

Intermec SF51 Manual

Intermec SF51 manual content summary: