Intermec SF51 SF51 Compliance Insert

Model SF51 Compliance Insert

For Users in the United States and Canada

This product conforms to the following approvals. The users of this product are cautioned to use accessories and peripherals

approved by Intermec Technologies Corporation. The use of accessories other than those recommended, or changes to this

product that are not approved by Intermec Technologies Corporation, may void the compliance of this product and may result in

the loss of the user’s authority to operate the equipment.

FCC Digital Emissions Compliance

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC

Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This

equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not

occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the

following measures:

•

Reorient or relocate the radio or television receiving antenna.

•

Increase the separation between the computer equipment and receiver.

•

Connect the equipment into an outlet on a circuit different from that to which the radio or television receiver is connected.

•

Consult the dealer or an experienced radio television technician for help.

Canadian Digital Apparatus Compliance

This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.

Conformité aux normes canadiennes sur les appareils numériques

Cet appareil numérique de la classe B respecte toutes les exigences du Réglement sur le matériel brouilleur du Canada.

Battery Information

Battery Recycling Information

Note:

In the U.S.A., the EPA does not consider spent Li-ion batteries as hazardous waste.

Caution: This marking indicates that the user should read all included documentation before use.

Attention: Ce marquage indique que l’usager doit, avant l’utilisation, lire toute la documentation incluse.

Caution: The battery pack used in this device may ignite, create a chemical burn hazard, explode, or release

toxic materials if mistreated. Do not incinerate, disassemble, or heat above 100°C (212°F). Charge only with

Intermec Models 074645 and 074646. Do not short circuit; may cause burns. Keep away from children.

Use only Intermec battery pack Model 074211. Use of incorrect battery pack may present risk of fire or

explosion. Promptly dispose of used battery pack according to the instructions.

Attention: Le bloc-piles utilisé dans cet appareil peut prendre feu, constituer un risque de brûlure chimique,

exploser ou dégager des substances toxiques s’il est manipulé de façon inappropriée. Ne pas jeter au feu,

démonter ou chauffer à plus de 100 °C (212 °F). Ne charger qu’avec les dispositifs Intermec 074645 et 074646.

Ne pas court-circuiter; cela pourrait causer des brûlures. Garder hors de la portée des enfants.

N’utiliser que le modèle de bloc-piles Intermec 074211. L’utilisation d’un mauvais bloc-piles pourrait

constituer un risque d’incendie ou d’explosion. Mettre rapidement au rebut tout bloc-piles usé, conformément

aux instructions.

Li-ion

Li-ion

This product contains or uses a lithium ion (Li-ion) main battery. When the battery reaches the end of its useful

life, the spent battery should be disposed of by a qualified recycler or hazardous materials handler. Do not mix

this battery with the solid waste stream. Contact your Intermec Technologies Service Center for recycling or

disposal information.

Ce produit contient ou utilise une pile principale au lithium-ion (Li-ion). Lorsque la batterie atteint la fin de sa

durée de vie utile, la batterie usées doivent être mises aux rebuts par un agent de recyclage ou un manipulateur de

matériaux dangereux agréé. Il ne faut pas mélanger la batterie aux autres déchets solides. Pour plus

d’informations sur le recyclage ou la mise aux rebuts, contacter votre centre de services Intermec Technologies.