Intermec SF61B SF61 Cordless Scanner Compliance Insert

1

SF61 Cordless Scanner Compliance Insert

Model 1016SP01B

For Users in English-Speaking Regions (en)

Users of this product are cautioned to use accessories and peripherals approved by Intermec Technologies Corporation. The use of accessories

other than those recommended, or changes to this product that are not approved by Intermec Technologies Corporation, may void the

compliance of this product and may result in the loss of the user’s authority to operate the equipment.

Battery, Charger, and Power Supply Information

Battery Recycling Information

Note: In the U.S.A., the EPA does not consider spent Li-ion batteries as hazardous waste.

Radiation Exposure Statement

Use of antennas and accessories not authorized may void the compliance of this product and may result in RF exposures beyond the limits

established for this equipment.

For North America:

The maximum IEEE C95.1 allowed SAR value is 1.6 W/kg over 1 g of tissue.

For Europe:

The maximum ICNIRP/CENELEC allowed SAR value is 2.0 W/kg over 10 g of tissue.

Radio Frequency (RF) Exposure and Specific Absorption Rate (SAR) Test Results for Intermec scanner SF61 (1016SP01B):

For Users in the U.S.A. and Canada

Laser Compliance and Precaution

The 1016SP01B HP is registered with the CDRH as a Class II LASER Product (21 CFR Subchapter J, Part 1040). This product has a maximum

output of 1 mW at 650 nm.

Note: There are no controls or adjustments provided for routine operation or maintenance of the 1016SP01B.

Caution: This marking indicates that the user should read all included documentation before use. Retain this supplement for future

reference.

Caution: For use with Intermec battery pack Model 1016AB01 only. No user-serviceable parts.

Caution: The battery pack used with this product may ingnite, create a chemincal burn hazard, explode, or release toxic materials if

mistreated. Do not incinerate, disassemble, or heat above 100°C (212°F). Do not short circuit; may cause burns. Keep away from

children.

Use only Intermec charger Model 074645 and 074646. Use of incorrect charger may present a risk of fire or explosion. Promptly

dispose of used battery pack according to the instructions.

Li-ion

Li-ion

This product contains or uses a lithium-ion (Li-ion) main battery. When the battery reaches the end of its useful life, the spent

battery should be disposed of by a qualified recycler or hazardous materials handler. Do not mix this battery with the solid

waste stream. Contact your Intermec Technologies Service Center for recycling or disposal information.

Warning: This equipment complies with International Commission on Non-Ionizing Radiation Protection (ICNIRP), IEEE C95.1,

Federal Communications Commission Office of Engineering and Technology (OET) Bulletin 65, Canada RSS-102, and European

Committee for Electrotechnical Standardization (CENELEC) limits for exposure to radio frequency (RF) radiation.

Radio Technology

W/Kg

Maximum SAR value tested or comment

Bluetooth

<1.6

- For body-worn operation.

Bluetooth

<2.0 W/kg (maximum SAR value tested for body-worn operation)

Caution: There are no user serviceable parts inside the 1016SP01B. Use of controls or adjustments, or performance of procedures

other than those specified herein, may result in hazardous laser light exposure of up to 1 mW at 650 nm.

IEC 60825-1: 2007

EN 60825-1: 2007

CLASS 2 LASER LIGHT

WHEN OPEN.

DO NOT STARE

INTO BEAM.