Intermec SG20 SG20B Cordless Scanner Compliance Insert

1

SG20B1D, SG20B2D, SG20B2DHC, SG20BHP, SG20BHPHC

Scanner Compliance Insert

Model SG20B

The users of this product are cautioned to use accessories and peripherals approved by Intermec Technologies Corporation. The use of

accessories other than those recommended, or changes to this product that are not approved by Intermec Technologies Corporation, may void

the compliance of this product and may result in the loss of the user’s authority to operate the equipment.

Battery, Charger and Power Supply Information

Battery Recycling Information

Note: In the U.S.A., the EPA does not consider spent Li-ion batteries as hazardous waste.

Laser Compliance and Precaution

The SG20B is registered with the CDRH as a Class II LASER Product (21 CFR Subchapter J, Part 1040). This product has a maximum output

of 1 mW at 650 nm.

Note: The procedure to change the battery can be found in the

SG20B Battery Instructions

.

Laser and Imager Compliance and Precaution

This product complies with the following standards for laser and LED safety:

•

IEC 60825-1:2007/EN 60825-1:2007 : Class 2 (1 mW, 650 nm)

•

IEC 60825-1/EN 60825-1 - Class 1 LED Product (imaging options only, no laser label)

If applicable, this product will be provided with a set of laser safety labels illustrated on the last page (s) of this document. If the proper label

language is not installed on the device, locate and apply the appropriate label over the existing label.

敬告本产品的用户，请务必使用 Intermec Technologies Corporation 许可的附件和外围设备。如果使用推荐附件之外的其它附件，

或未经 Intermec Technologies Corporation 许可而擅自改装本产品，都可能会使本产品的符合性无效，并可能会导致用户失去操作

本设备的权利。

Caution: This marking indicates that the user should read all included documentation before use. Retain this supplement for future

reference.

Caution: For use with Intermec model SG20BS or SG20CB and battery pack Model SGBAT only. For power supply, use Intermec

Model AE26.

Caution: The battery pack used with this product may ingnite, create a chemincal burn hazard, explode, or release toxic materials if

mistreated. Do not incinerate, disassemble, or heat above 100°C (212°F). Do not short circuit; may cause burns. Keep away from

children.

Use only Intermec charger Models SG20BS and SG20CB. Use of incorrect charger may present a risk of fire or explosion. Promptly

dispose of used battery pack according to the instructions.

Li-ion

Li-ion

This product contains or uses a lithium ion (Li-ion) main battery. When the battery reaches the end of its useful life, the spent

battery should be disposed of by a qualified recycler or hazardous materials handler. Do not mix this battery with the solid

waste stream. Contact your Intermec Technologies Service Center for recycling or disposal information.

Caution: The battery is the only serviceable part inside the SG20B. Use of controls or adjustments, or performance of procedures

other than those specified herein, may result in hazardous laser light exposure of up to 1 mW at 630-670 nm.

注意：该标记指示在使用之前用户应阅读所有包含的文档。请保留这份补充材料，以备日后参考。

Complies with 21 CFR 1040

with Laser Notice 50. This

device complies with

part 15 of the FCC Rules.

IEC 60825-1: 2007

EN 60825-1: 2007