Intermec SR30 SR30 Compliance Insert

SR30 Compliance Insert

For Users in the United States and Canada

Users of this product are cautioned to use accessories and peripherals approved by Intermec Technologies Corporation. The use of accessories

other than those recommended, or changes to this product that are not approved by Intermec Technologies Corporation, may void the

compliance of this product and may result in the loss of the user’s authority to operate the equipment.

FCC Digital Emissions Compliance

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates

uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference

to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following measures:

•

Reorient or relocate the radio or television receiving antenna.

•

Increase the separation between the computer equipment and receiver.

•

Connect the equipment into an outlet on a circuit different from that to which the radio or television receiver is connected.

•

Consult the dealer or an experienced radio television technician for help.

Canadian Digital Apparatus Compliance

This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.

Conformité aux normes canadiennes sur les appareils numériques

Cet appareil numérique de la classe B respecte toutes les exigences du Réglement sur le matériel brouilleur du Canada.

Some cabled connections require the use of a separate power supply.

Certaines connexions câblées nécessitent un bloc d’alimentation distinct.

CE Marking:

Refer to the Declaration of Conformity for a list of the EU Directives and Standards that this product complies with.

Marque CE:

Pour la liste des directives et normes de l’UE, reportez-vous à la Déclaration de conformité à laquelle ce produit se conforme.

For Users Outside of the United States or Canada

Some cabled connections require the use of a separate power supply.

Linear Imager Compliance and Precaution

This product complies with the following standards for laser and LED safety:

IEC 60825-1 / EN 60825-1 - Class 1 LED Product

Caution: This marking indicates that the user should read all included documentation before use.

Attention: Ce marquage indique que l’usager doit, avant l’utilisation, lire toute la documentation incluse.

Caution: For power supply, use Intermec Model AE26. No user-serviceable parts.

Attention: Pour la source d’alimentation, utilisez Intermec modèle AE26. Il ne contient aucune pièce réparable par

l’utilisateur.

Caution: This marking indicates that the user should read all included documentation before use.

Caution: For power supply, use Intermec Model AE26. No user-serviceable parts.