Intermec SR61 SR61 Dangle Suspension Instructions
Intermec SR61 Manual
 |
View all Intermec SR61 manuals
Add to My Manuals
Save this manual to your list of manuals |
Intermec SR61 manual content summary:
- Intermec SR61 | SR61 Dangle Suspension Instructions - Page 1
Instructions SR61 Dangle Suspension - Intermec SR61 | SR61 Dangle Suspension Instructions - Page 2
Contents Learning About the Dangle Suspension 3 Installing the Dangle Suspension 3 Adjusting the Dangle Suspension 5 Adjusting the Resting Height of the SR61 6 Adjusting the Spring Tension 7 Adjusting the Drag 8 ii SR61 Dangle Suspension Instructions - Intermec SR61 | SR61 Dangle Suspension Instructions - Page 3
or other secure structure Note: Do not lubricate the dangle suspension. These instructions describe how to: 1 Install the dangle suspension. 2 Adjust the above the area where you are going to be using the SR61. 2 Mount the dangle suspension to your vehicle or other secure structure using - Intermec SR61 | SR61 Dangle Suspension Instructions - Page 4
rapidamente, poderá causar ferimentos. Precaución: No mueva el cable hacia abajo. Tiene resorte y podría causar lesiones si se deja rebotar a su posición original. 5 Attach the SR61 to the dangle suspension as shown in the next two illustrations. 4 SR61 Dangle Suspension Instructions - Intermec SR61 | SR61 Dangle Suspension Instructions - Page 5
Adjusting the Dangle Suspension After you install the dangle suspension, you can make these adjustments based on your preferences: • Adjust the resting height of the SR61. • Adjust the lift (spring tension). • Adjust the drag brake. SR61 Dangle Suspension Instructions 5 - Intermec SR61 | SR61 Dangle Suspension Instructions - Page 6
. Ball stop 2 Use a #1 Phillips screwdriver to loosen the screws on the ball stop. 3 Slide the ball stop up or down the cable so that the SR61 is positioned at your preferred resting height. 4 Tighten the screws on the ball stop. 6 SR61 Dangle Suspension Instructions - Intermec SR61 | SR61 Dangle Suspension Instructions - Page 7
knob clockwise until the ball stop rests at the dangle suspension. • To decrease spring tension, press the tension release button. Tension release button Tension knob SR61 Dangle Suspension Instructions 7 - Intermec SR61 | SR61 Dangle Suspension Instructions - Page 8
drag screw counter-clockwise. Drag screw Worldwide Headquarters 6001 36th Avenue West Everett, Washington 98203 U.S.A. tel 425.348.2600 fax 425.355.9551 www.intermec.com © 2007 Intermec Technologies Corporation. All rights reserved. SR61 Dangle Suspension Instructions *943-024-001* P/N 943-024-001
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
 |
 |
SR61 Dangle
Suspension
Instructions