Kenmore 60793 Use and Care Guide
Kenmore 60793 - Elite 1 HP Food Waste Disposer Manual
 |
View all Kenmore 60793 manuals
Add to My Manuals
Save this manual to your list of manuals |
Kenmore 60793 manual content summary:
- Kenmore 60793 | Use and Care Guide - Page 1
Dishwasher Drain Connection Kit, Air Gap, Electrical On/Off Switch, Drain Tube Extension Read through the entire Installation, Care & Use manual before installing the disposer. Determine which of the tools, materials, and accessories you will need before you begin. Make sure you have all necessary - Kenmore 60793 | Use and Care Guide - Page 2
= 9 7/16" 4" 60571/60562 12 5/8' 6" 4= 60572/60563 12 5/8" 6" 4' 60793 12 3/4" 6 11/16 = 4" • Indicates Batch Feed Model D 6 5/16" 6 5/16" 7 1/4" 8 1/2" 8 1/2" 7 1/2" 7 1/4" is installed.) I sfkyipouahaeraedretpolaIcnisntgrucationnexis7t.ing disposer, go to Instruction 6. If this is a - Kenmore 60793 | Use and Care Guide - Page 3
wires. Loosen screw(s) on electrical clamp connector and remove wires from disposer. If the new disposer mounting is the same as old one, remove mounting assembly I from disposer (Instruction 3) and go to Instruction 7. • If the new disposer mounting is different from the old one (or you wish to - Kenmore 60793 | Use and Care Guide - Page 4
service panel until proper grounds are installed. There are two ways to connect electrical power to your disposer: 1.) Direct wire 2.) Plug in cord - installed at factory, or from Kenmore Kit #60686 (for all models listed in this manual) Disposer appliance. Grounding Instructions for Cord Connected - Kenmore 60793 | Use and Care Guide - Page 5
tube (B) (see Figure 11-3). 2. Rubber gasket (C) must be installed on top end of discharge tube. Secure metal flange and discharge tube to disposer with bolt (D). 3. Rotate disposer so that discharge tube is aligned with drain trap. (To prevent leaks, do not pull or bend discharge tube to drain trap - Kenmore 60793 | Use and Care Guide - Page 6
disposer, containing important information in the event service is required. 1. Detach perforated portion of specification decal from lower portion of disposer. 2. Apply decal to disposer : • Read all instructions before using the appliance. This product is designed to dispose of normal household - Kenmore 60793 | Use and Care Guide - Page 7
disposer and activated by the stopper. (See Instruction 1,/nstal/ation Dimensions chart, for model reference.) 1. Read important safety instructions contained in the Installation, Care & Use manual on the disposer bottom (see Figure C). (If the motor remains inoperative, check the service panel for - Kenmore 60793 | Use and Care Guide - Page 8
KENMORE FOOD WASTE DISPOSER WARRANTY Model Model Model Model Model Model Model Model Warranty Model 60562 Model 60563 Model 60571 Model 60572 Model 60581 Model 60591 Model 60793 Four in this disposer. WARRANTY SERVICE IS AVAILABLE BY SIMPLY CONTACTING THE NEAREST SEARS SERVICE CENTER/DEPARTMENT
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
 |
 |
f
®
FOOD WASTE
DISPOSERS
Installation,
Care & Use Manual
TOOLS
AND
MATERIALS
YOU WILL
NEED:
Slotted Screwdriver,
Adjustable
Pliers, Plumber's
Putty,
Electrical
Tape
TOOLS,
MATERIALS,
AND ACCESSORIES
YOU MAY NEED:
Phillips
Screwdriver,
Drain Auger, 3/8" Electrical
Clamp
Connector,
Wire Nuts (2), Second 1 1/2" Drain Trap,
Hammer,
Hacksaw, Water Hose Clamp,
Pipe Wrench,
Copper Ground Wire, Dishwasher
Drain Connection
Kit, Air
Gap, Electrical
On/Off Switch,
Drain Tube Extension
Read
through
the
entire
Installation,
Care
& Use
manual
before
installing
the
dis-
poser.
Determine
which
of the
tools,
materials,
and accessories
you will need
before
you
begin.
Make
sure
you
have
all
necessary
disposer
parts
before
install-
ing the
disposer
(see
part
identification
diagram
below).
(_/A
JlB
O--c
O--G
Mounting
Assembly
A: Stopper
B: Sink Flange
C: Fiber Gasket
D: Backup
Ring
E: Mounting Ring
F: Screws (3)
G: Snap
Ring
Disposer
H: Mounting
Gasket/Splash
Baffle
1: Lower Mounting Ring
J: Dishwasher Inlet
K:
Discharge
Outlet
L: Wrenchette
_
@-N
#1
.-0
OR
--#2
___N
Two-Bolt
Discharge
N:
Bolt
(2)
_10:
Discharge Tube (1-1/2"
Diam.)
P: Flange
Q:
Gasket
OR
One-Bolt
Discharge
N:
Bolt
#20:DischargeTube
(1-1/2" Diam.)
P: Flange
Q:
Gasket
SAFETY
SYMBOLS
Danger indicates
an
imminently
hazardous
situation
which,
if not avoided,
will result in death or
serious
injury.
I
t"
WARNINGI
Warning
indicates
a
potentially
hazardous
situation
which, if not avoided, could result in
death
or serious injury.
[_kCAUTION]
Caution
indicates a
potentially
hazardous
situation
which,
if not
avoided,
may result in minor or
moderate
injury,