KitchenAid KERS303BSS Installation Guide

KitchenAid KERS303BSS Manual

KitchenAid KERS303BSS manual content summary:

  • KitchenAid KERS303BSS | Installation Guide - Page 1
    INSTALLATION INSTRUCTIONS 30" (76 CM) FREESTANDING ELECTRIC RANGES Table of Contents RANGE SAFETY 2 INSTALLATION REQUIREMENTS 3 Tools and Parts 3 Location Requirements 3 Electrical Requirements - U.S.A. Only 5 INSTALLATION INSTRUCTIONS 6 Unpack Range 6 Install Anti-Tip Bracket 6 Electrical
  • KitchenAid KERS303BSS | Installation Guide - Page 2
    RANGE SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual anti-tip bracket if range is moved. Do not operate range without anti-tip bracket installed and engaged. Failure to follow these instructions can result in death
  • KitchenAid KERS303BSS | Installation Guide - Page 3
    screwdriver ■ ¼" drive ratchet ■ Phillips screwdriver ■ Level ■ Hammer ■ Hand or electric drill ■ Wrench or pliers ■ Marker or pencil ■ ¼" nut driver and installations require: ■ When this range is installed in a mobile home, it must be secured per the instructions in this document. ■ Four-
  • KitchenAid KERS303BSS | Installation Guide - Page 4
    of the door or either side of the drawer) IMPORTANT: Range must be level after installation. Follow the instructions in the "Level Range" section. Using the cooktop as a reference for leveling the range is not recommended. *Range can be raised approximately 1" (2.5 cm) by adjusting the leveling legs
  • KitchenAid KERS303BSS | Installation Guide - Page 5
    installed by a qualified electrician. Electrical Connection To properly install your range, you must determine the type of electrical connection you will be using and follow the instructions provided for it here. ■ Range must be connected to the proper electrical voltage and frequency as specified
  • KitchenAid KERS303BSS | Installation Guide - Page 6
    -half turn. C A Install Anti-Tip Bracket WARNING Tip Over Hazard A child or adult can tip the range and be killed. Install anti-tip bracket to floor or wall per installation instructions. Slide range back so rear range foot is engaged in the slot of the anti-tip bracket. Re-engage anti-tip bracket
  • KitchenAid KERS303BSS | Installation Guide - Page 7
    Move range close enough to opening to allow for final electrical connections. Remove shipping base, cardboard or hardboard from under range. 7. Move range into range forward onto shipping base, cardboard or hardboard to continue installing the range using the following installation instructions.
  • KitchenAid KERS303BSS | Installation Guide - Page 8
    and toward you to remove cover from range. Electrical Shock Hazard Disconnect power before servicing. Use 8 gauge copper or 6 gauge aluminum wire. Electrically ground range. Failure to follow these instructions can result in death, fire, or electrical shock. Style 1: Power supply cord strain relief
  • KitchenAid KERS303BSS | Installation Guide - Page 9
    following instructions for your type of electrical connection: 4-wire (recommended) 3-wire (if 4-wire is not available) Electrical power supply cord through the strain relief on the cord/conduit plate on bottom of range. Allow enough slack to easily attach the wiring to the terminal block. A
  • KitchenAid KERS303BSS | Installation Guide - Page 10
    6. Replace terminal block access cover. Direct Wire Installation: Copper or Aluminum Wire This range may be connected directly to the fuse disconnect or circuit breaker box. Depending on your electrical supply, make the required 3-wire or 4-wire connection. 1. Strip outer covering back 3" (7.6 cm
  • KitchenAid KERS303BSS | Installation Guide - Page 11
    out and removed. A B C A. Metal ground strap B. Discard C. Ground-link screw 2. Use a Phillips screwdriver to remove the ground-link screw from the back of the range. Save the ground-link screw and the end of the ground link under the screw. 3. Pull the wires through the strain relief on bottom of
  • KitchenAid KERS303BSS | Installation Guide - Page 12
    . Slide the range forward and determine if there is an obstruction between the range and the mounting wall. If you need assistance or service, refer to the "Assistance or Service" section of the Use and Care Guide, or the cover or "Warranty" section of the User Instructions, for contact information
  • KitchenAid KERS303BSS | Installation Guide - Page 13
    without anti-tip bracket installed and engaged. Please reference the "Assistance or Service" section of the Use and Care Guide, or the cover or "Warranty" section of the User Instructions, to contact service. Level Range Determine if you have AquaLift® Technology or Steam Clean by referring to the
  • KitchenAid KERS303BSS | Installation Guide - Page 14
    an "F9" or "F9, E0" error code, the electrical outlet in the home may be miswired. Contact a qualified electrician to verify the electrical supply. ■ See the "Troubleshooting" section in the Use and Care Guide or User Instructions. When the range has been on for 5 minutes, check for heat. If
  • KitchenAid KERS303BSS | Installation Guide - Page 15
    instructions. Slide range back so rear range foot is engaged in the slot of the anti-tip bracket. Re-engage anti-tip bracket if range is moved. Do not operate range Engaged" section. 6. Check that range is level. Electrical Shock Hazard Disconnect power before servicing. Replace all parts and panels
  • KitchenAid KERS303BSS | Installation Guide - Page 16
    W10403811C ®/™ ©2012 Whirlpool. All rights reserved. 8/12 Printed in U.S.A.
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16

INSTALLATION INSTRUCTIONS
30" (76 CM) FREESTANDING ELECTRIC RANGES
Table of Contents
RANGE SAFETY
..................................................................................
2
INSTALLATION REQUIREMENTS
.....................................................
3
Tools and Parts
.................................................................................
3
Location Requirements
.....................................................................
3
Electrical Requirements - U.S.A. Only
..............................................
5
INSTALLATION INSTRUCTIONS
.......................................................
6
Unpack Range
..................................................................................
6
Install Anti-Tip Bracket
......................................................................
6
Electrical Connection - U.S.A. Only
..................................................
8
Verify Anti-Tip Bracket Is Installed and Engaged
...........................
12
Level Range
....................................................................................
13
Warming Drawer or Premium Storage Drawer
...............................
13
Storage Drawer
...............................................................................
14
Oven Door
.......................................................................................
14
Complete Installation
......................................................................
14
Moving the Range
...........................................................................
15
IMPORTANT:
Save for local electrical inspector's use.
W10403811C