KitchenAid KERS505XSS Installation Guide
KitchenAid KERS505XSS Manual
 |
UPC - 883049199276
View all KitchenAid KERS505XSS manuals
Add to My Manuals
Save this manual to your list of manuals |
KitchenAid KERS505XSS manual content summary:
- KitchenAid KERS505XSS | Installation Guide - Page 1
RANGE WITH DOUBLE OVENS INSTRUCTIONS D'INSTALLATION POUR CUISINIÈRE ÉLECTRIQUE AUTOPORTANTE AVEC FOURS DOUBLES Table of Contents RANGE SAFETY 1 INSTALLATION REQUIREMENTS 2 Tools and Parts 2 Location Requirements 2 Electrical Requirements - U.S.A. Only 4 Electrical Requirements - Canada - KitchenAid KERS505XSS | Installation Guide - Page 2
the installer's responsibility to comply with installation clearances specified on the model/serial rating plate. The model/serial rating plate is located behind the control panel. ■ The range should be located for convenient use in the kitchen. ■ To eliminate the risk of burns or fire by reaching - KitchenAid KERS505XSS | Installation Guide - Page 3
Model/serial/rating plates may be rotated up from behind the control panel for viewing from the front of the range. ***Excludes handle. Dimension given is from wall to front of oven door and will vary based on electric 28 MSG sheet steel, 0.015" (0.4 mm) stainless steel, 0.024" (0.6 mm) aluminum or - KitchenAid KERS505XSS | Installation Guide - Page 4
can result in a risk of electric shock. Check with a qualified electrician or service technician if you are in instructions provided for it here. ■ Range must be connected to the proper electrical voltage and frequency as specified on the model/serial number rating plate. The model/serial/rating - KitchenAid KERS505XSS | Installation Guide - Page 5
Toronto, ON M9W 1R3 CANADA ■ Check with a qualified electrical installer if you are not sure the range is properly grounded. Range Rating* 120/240 Volts 8.8 listed on the model/serial rating plate. **If connecting to a 50-amp circuit, use a 50-amp rated cord with kit. For 50-amp rated cord kits, use - KitchenAid KERS505XSS | Installation Guide - Page 6
INSTALLATION INSTRUCTIONS Unpack Range WARNING Excessive Weight Hazard Use two or more people to move and install range. Failure to do so can result in back or other injury. 1. Remove shipping materials, tape and film from the range. Keep cardboard bottom under range. 2. Remove oven racks and parts - KitchenAid KERS505XSS | Installation Guide - Page 7
the anti-tip bracket that is taped inside the upper oven with the package containing literature. Floor Mounting 2. Determine which floor you can use the wall mounting method. 3. Determine and mark edge of range in the cutout space. The mounting bracket can be installed on either the left side - KitchenAid KERS505XSS | Installation Guide - Page 8
grounded outlet. Failure to follow these instructions can result in death, fire, or electrical shock. Electrical Shock Hazard Disconnect power before servicing. Use 8 gauge copper or 6 gauge aluminum wire. Electrically ground range. Failure to follow these instructions can result in death, fire, or - KitchenAid KERS505XSS | Installation Guide - Page 9
connector in the opening. 5. Replace back panel and screws on rear of range. 6. Complete installation following instructions for your type of electrical connection: 4-wire (recommended) 3-wire (if 4-wire is not available) Electrical Connection Options If your home has: And you will be Go to - KitchenAid KERS505XSS | Installation Guide - Page 10
local codes prohibit grounding through the neutral 1. Part of metal ground strap must be cut the strain relief in the cord/conduit plate on bottom of range. Allow enough slack to easily attach the wiring to the supply cord replacement, only use a power cord rated at 250 volts minimum, 40 amps or 50 - KitchenAid KERS505XSS | Installation Guide - Page 11
power supply cord replacement, only use a power cord rated at 250 volts minimum, 40 amps or 50 amps range may be connected directly to the fuse disconnect or circuit breaker box. Depending on your electrical codes prohibit grounding through the neutral 1. Part of metal ground strap must be cut out - KitchenAid KERS505XSS | Installation Guide - Page 12
Torque 8 gauge copper 6 gauge aluminum 25 lbs-in. (2.8 N-m) 35 lbs-in. (4.0 N-m) 5. Use Phillips screwdriver to connect the bare (green) ground wire to the range with the ground-link screw. The ground wire must be attached first and must not contact any other terminal. 6. Use ³⁄₈" nut driver to - KitchenAid KERS505XSS | Installation Guide - Page 13
and oven. See the Use and Care Guide for specific instruction on range operation. If range does not operate, check the following: ■ Household fuse is intact and tight; or circuit breaker has not tripped. ■ Range is plugged into an outlet. ■ Electrical supply is connected. ■ See "Troubleshooting" in - KitchenAid KERS505XSS | Installation Guide - Page 14
and look underneath the bottom of the range: ■ Look for the anti-tip bracket securely attached to floor or wall. ■ Slide range back so rear range foot is under anti-tip bracket. Electrical Shock Hazard Disconnect power before servicing. Replace all parts and panels before operating. Failure to do - KitchenAid KERS505XSS | Installation Guide - Page 15
Notes 15 - KitchenAid KERS505XSS | Installation Guide - Page 16
est le danger potentiel et vous disent comment réduire le risque de blessure et ce qui peut se produire en cas de non-respect des instructions. AVERTISSEMENT Risque de basculement Un enfant ou une personne adulte peut faire basculer la cuisinière ce qui peut causer un décès. Joindre la bride - KitchenAid KERS505XSS | Installation Guide - Page 17
d'entreprendre l'installation. Lire et suivre les instructions fournies avec chacun des outils de la liste conçu pour l'utilisation avec une cuisinière. Pour service 250 volts minimum, 40 A ou 50 A, Part 3280 (anciennement Federal Standard for Mobile Home Construction and Safety, Title 24, HUD Part - KitchenAid KERS505XSS | Installation Guide - Page 18
36" (91,4 cm) IMPORTANT : En cas d'installation d'une hotte ou d'un ensemble hotte/micro-ondes au-dessus de la cuisinière, suivre les instructions fournies avec la hotte concernant les dimensions de dégagement à respecter au-dessus de la surface de la table de cuisson. Une cuisinière autoportante - KitchenAid KERS505XSS | Installation Guide - Page 19
120/208 volts A Electrical Shock Hazard Electrically ground range. Failure to do so can result in death, fire, or electrical shock. Si l' des codes ci-dessus, contacter : Canadian Standards Association 178 Rexdale Blvd. Toronto, ON M9W 1R3 CANADA. 8,8 à 16,5 kW 7,8 à 12,5 kW 40 ou 50** 16,6 à 22,5 - KitchenAid KERS505XSS | Installation Guide - Page 20
personnes pour déplacer et installer la cuisinière. Le non-respect de cette instruction peut causer une blessure au dos ou d'autre blessure. 1. Ôter les re la cuisinière en guise de support lorsque la cuisinière est placée sur sa partie postérieure. 4. À l'aide de deux personnes ou plus, saisir - KitchenAid KERS505XSS | Installation Guide - Page 21
mm) qui correspondent aux trous de la bride selon la méthode de montage déterminée. Voir ci-dessous. A B A. Vis n°12 x 1⁵⁄₈" B. Bride antibasculement 5. À l'aide d'un tournevis Phillips, monter la bride antibasculement sur le mur ou sur le plancher avec les deux vis n° 12 x 1⁵⁄₈" fournies. 21 - KitchenAid KERS505XSS | Installation Guide - Page 22
déformés. 8. Mettre l'appareil sous tension. Mettre en marche les éléments de surface et le four. Pour des instructions spécifiques concernant l'utilisation de la cuisinière, consulter le Guide d'utilisation et d'entretien. Si la cuisinière ne fonctionne pas, contrôler ce qui suit : ■ Les fusibles - KitchenAid KERS505XSS | Installation Guide - Page 23
cuisinière se trouve sous la bride antibasculement. Joindre de nouveau la bride antibasculement si la cuisinière est déplacée. Le non-respect de ces instructions peut causer un décès ou des brûlures graves aux enfants et aux adultes. Lorsqu'on déplace la cuisinière, la faire glisser sur une - KitchenAid KERS505XSS | Installation Guide - Page 24
W10289536A © 2010. All rights reserved. Tous droits réservés. 1/10 Printed in U.S.A. Imprimé aux É.-U.
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
-
21
-
22
-
23
-
24
 |
 |
INSTALLATION INSTRUCTIONS
FREESTANDING ELECTRIC RANGE WITH DOUBLE OVENS
INSTRUCTIONS D'INSTALLATION POUR CUISINIÈRE
ÉLECTRIQUE AUTOPORTANTE AVEC FOURS DOUBLES
RANGE SAFETY
Table of Contents
Table des matières
RANGE SAFETY
.........................................................................
1
INSTALLATION REQUIREMENTS
............................................
2
Tools and Parts
........................................................................
2
Location Requirements
............................................................
2
Electrical Requirements - U.S.A. Only
.....................................
4
Electrical Requirements - Canada Only
..................................
5
INSTALLATION INSTRUCTIONS
..............................................
6
Unpack Range
.........................................................................
6
Adjust Leveling Legs
................................................................
6
Install Anti-Tip Bracket
.............................................................
7
Electrical Connection - U.S.A. Only
.........................................
8
Verify Anti-Tip Bracket Location
............................................
13
Level Range
...........................................................................
13
Complete Installation
.............................................................
13
Moving the Range
..................................................................
14
SÉCURITÉ DE LA CUISINIÈRE
..............................................
16
EXIGENCES D’INSTALLATION
..............................................
17
Outils et pièces
.....................................................................
17
Exigences d’emplacement
...................................................
17
Spécifications électriques – Canada seulement
..................
19
INSTRUCTIONS D'INSTALLATION
.......................................
20
Déballage de la cuisinière
.....................................................
20
Réglage des pieds de nivellement
........................................
20
Installation de la bride antibasculement
...............................
21
Vérification de l'emplacement de la
bride antibasculement
..........................................................
22
Réglage de l'aplomb de la cuisinière
....................................
22
Achever l’installation
.............................................................
22
Déplacement de la cuisinière
................................................
23
W10289536A
IMPORTANT:
Save for local electrical inspector's use.
IMPORTANT :
À conserver pour consultation par l'inspecteur local des installations électriques.
You can be killed or seriously injured if you don't immediately
You
can be killed or seriously injured if you don't follow
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can
happen if the instructions are not followed.
Your safety and the safety of others are very important.
We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety
messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING.”
These words mean:
follow instructions.
instructions.
DANGER
WARNING