LiftMaster 811LM Owners Manual - English French Spanish
LiftMaster 811LM Manual
View all LiftMaster 811LM manuals
Add to My Manuals
Save this manual to your list of manuals |
LiftMaster 811LM manual content summary:
- LiftMaster 811LM | Owners Manual - English French Spanish - Page 1
for each remote control you would like to program. If you would like to program an 813LM as an OPEN, CLOSE, STOP, refer to the 850LM receiver manual. For programming to the 860LM receiver or to a Security+ 2.0® compatible gate operator, please refer to the receiver/operator instructions manual for - LiftMaster 811LM | Owners Manual - English French Spanish - Page 2
Remote Control Battery The Lithium battery should produce power for up to 3 years. To replace battery: To prevent possible SERIOUS INJURY or DEATH: • NEVER allow small children near batteries. • If battery are prohibited. THERE ARE NO USER SERVICEABLE PARTS. This device complies with Part 15 - LiftMaster 811LM | Owners Manual - English French Spanish - Page 3
811LM ET 813LM Cet article est utilisé avec les récepteurs universels modèles 850LM et 860LM, ainsi qu'avec toute commande de barrière LiftMaster compatible 860LM ou un dispositif de commande compatible à un Security+ 2.0®, reportez-vous au manuel d'instructions récepteur/dispositif de commande pour - LiftMaster 811LM | Owners Manual - English French Spanish - Page 4
La pile de télécommande La pile au Lithium pour devraient durer trois ans. Pour remplacer la pile : Pour prévenir d''eventuelles BLESSURES GRAVES ou la MORT : • Ne jamais laisser de petits enfants à proximité des piles. • Aviser immédiatement un médecin en cas d'ingestion de la pile. Pour réduire - LiftMaster 811LM | Owners Manual - English French Spanish - Page 5
CONTROL REMOTO PARA PORTONES MODELOS 811LM Y 813LM Introducción Este producto se usa con los receptores universales modelo 850LM y 860LM, y con toda unidad operadora de portones LiftMaster compatible con Security+ 2.0®. Según el canal del receptor es posible programar hasta 20 o 50 combinaciones de - LiftMaster 811LM | Owners Manual - English French Spanish - Page 6
La pila del control remoto La batería de Litio puede durar hasta 3 años. Para cambiar la batería: Para evitar la posibilidad de LESIONES GRAVES O incluso LA MUERTE: • NUNCA permita - LiftMaster 811LM | Owners Manual - English French Spanish - Page 7
FOR TECHNICAL SUPPORT DIAL OUR TOLL FREE NUMBER: POUR OBTENIR DE L'ASSISTANCE TECHNIQUE, COMPOSER NOTRE NUMÉRO GRATUIT : MARQUE NUESTRO NÚMERO GRATUITO PARA SOPORTE TÉCNICO: 1-800-528-9131 LiftMaster.com - LiftMaster 811LM | Owners Manual - English French Spanish - Page 8
114A4298E © 2014 LiftMaster All Rights Reserved Tous droits réservés Todos los derechos reservados
To prevent possible SERIOUS INJURY or
DEATH from a moving gate or garage door:
•
ALWAYS keep remote controls out of
reach of children. NEVER permit children
to operate, or play with remote control
transmitters.
•
Activate gate or door ONLY when it can be
seen clearly, is properly adjusted, and
there are no obstructions to door travel.
•
ALWAYS keep gate or garage door in sight
until completely closed. NEVER permit
anyone to cross path of moving gate or
door.
Introduction
This product is for use with models 850LM and
860LM universal receivers as well as any
Security+ 2.0
®
compatible LiftMaster gate
operators. Depending on the receiver channel,
you may program up to 20 or 50 remote control
dip switch configurations to your receiver. To
exceed the 20/50 limit, match the dip switches
in the new remote control to the dip switches in
an existing remote control.
GATE KEY REMOTE CONTROLS
MODELS 811LM AND 813LM
Set the Dip Switches
1
Slide the cover open to access the dip
switches in the remote control.
2
Use a pen or screwdriver to slide the dip
switches to any position you want (ON or
OFF).
1
Press and release the Learn button for the
selected channel on the receiver. The
corresponding LED will glow steadily for 30
seconds.
2
Within 30 seconds press and hold the button
on the remote control that you wish to
program to the receiver.
3
Release the remote control button when the
LED on the receiver blinks, then turns off.
Programming is complete.
Repeat the steps above for each remote control
you would like to program.
If you would like to program an 813LM as an
OPEN, CLOSE, STOP, refer to the 850LM
receiver manual.
Programming
Learn Buttons
811LM
813LM
For programming to the 860LM receiver or to a
Security+ 2.0
®
compatible gate operator, please
refer to the receiver/operator instructions manual
for location of the learn button(s).
WARNING:
This product can expose you to chemicals including lead, which are known to
the State of California to cause cancer or birth defects or other reproductive harm. For more
information go to
www.P65Warnings.ca.gov