LiftMaster HPH1MC Clopay Model 3718 Specifications

Clopay Model 3718 Specifications

PART 1 GENERAL

1.01 Section Includes

A.

Upward Acting Sectional Steel Doors, including unit sections, brackets, tracks, glazing, counter balance

mechanisms, and hardware.

1.02 Related Work

A.

Opening preparation, miscellaneous or structural steel, finish or field painting, electrical wires, wiring,

disconnect switches, conduit are in the scope of the work of other sections or trades.

B.

Submit manufacturer’s product data and installation instructions for each type of sectional door. Include

both published data and any specific data prepared for this project.

1.03 Single Source Responsibility

A.

Provide door, tracks, motors and accessories from one manufacturer for each type of door. Provide

secondary components from source acceptable to manufacturer of primary components.

PART 2 PRODUCT

2.01 Manufacturer

A.

Upward Acting Sectional Steel Doors are to be Clopay

®

Model 3718 as manufactured by Clopay Building

Products Company, Inc.

2.02 Material /Construction

A. Type:

1-3/4” (44.45 mm) thick, sandwich construction, roll-formed commercial steel.

B. Size:

Standard maximum door size is 26’2” (7.98 m) wide by 20’ (6.1 m) high.

C. Section Joint:

Sections to form a weather-tight tongue and groove joint.

D. Material :

Hot-dipped galvanized, complying with ASTM A-924, A-653, exterior and

interior skins

separated to form thermal break and filled by foamed-in-place polyurethane core; standard lift operating

style with track and hardware; complying with DASMA 102,

commercial application.

E. Finish:

Pre-finished interior and exterior skins with 1-mil, three coat baked-on polyester topcoat over

primer on a phosphate coating.

1. Exterior Skin:

27 gauge (.016”, (.40 mm) minimum) exterior flush steel face sheet with stucco

texture. Color: white, brown, tan, grey, Trinar

®

white, Trinar

®

beige

2. Interior Skin:

27 gauge (.016”, (.40 mm) minimum) interior steel face sheet with stucco texture,

shallow U-ribbed. Color: white

2.03 Related Door Components

A. End Stiles:

Galvanized steel. Attachment hardware to have pre-punched holes.

1.

18 gauge (.045”, (1.14 mm) minimum) single end hinge style.

2.

16 gauge (.056”, (1.42 mm) minimum) double end hinge style.

B. Hinge and Roller Assemblies:

Hinges and brackets to be 14 gauge (.070”, (1.78 mm) minimum)

galvanized steel.