LiftMaster IPAC IPAC Site Survey Manual
LiftMaster IPAC Manual
 |
View all LiftMaster IPAC manuals
Add to My Manuals
Save this manual to your list of manuals |
LiftMaster IPAC manual content summary:
- LiftMaster IPAC | IPAC Site Survey Manual - Page 1
Support (IT) Contact: Phone Number: Phone Number: Internet & SIP Requirements This product utilizes computer network connections and communication. The site MUST have internet service and SIP service work with the IPAC unit. We recognize there are many SIP providers and LiftMaster is not endorsing - LiftMaster IPAC | IPAC Site Survey Manual - Page 2
❑ No - Consult with LiftMaster technical support. The access control panel metallic cold water pipe, or existing electrical system) for the installation. A retrofit kit is Camera ❑ Wiegand HID reader(s) ❑ Retrofit Kit ❑ Weather protective gear (pop up tent) ❑ Passport receiver FOR TECHNICAL SUPPORT - LiftMaster IPAC | IPAC Site Survey Manual - Page 3
Notes 3 - LiftMaster IPAC | IPAC Site Survey Manual - Page 4
Notes 114A4574B © 2013, The Chamberlain Group, Inc. All Rights Reserved
-
1 -
2 -
3 -
4
 |
 |
Site Survey
The purpose of the site survey is to:
•
Determine if a site meets all the requirements for the
installation of the access control panel.
•
Identify any missing requirements at the site.
•
Record the network settings used to configure the
access control panel.
•
Determine the location of the access control panel.
•
Determine if any optional equipment is needed for the site.
This product is a network enabled and Internet ready access control solution for community doors and gates that features a simple and
intuitive resident and visitor experience.
Internet & SIP Requirements
Document Objectives
Site Information
Overview
This product utilizes computer network connections and communication. The site MUST have internet service and SIP service for the
access control panel to operate.
INTERNET SERVICE:
SIP SERVICE:
❑
Yes – The site has internet service.
❑
Yes – The site has SIP service.
❑
No – Order internet service.
❑
No – Order SIP service.
NETWORK CONNECTION:
The access control panel MUST be connected to a 10/100 (minimum) local area network (LAN) device such as a hub, switch or router
with a CAT 5/6 network cable. The LAN port on the main board is a 10/100 Ethernet interface with an RJ45 jack.
❑
Yes – The site has access to a LAN device. Where is the LAN device located?
❑
No – Setup a network device such as a hub, switch or router on site.
NETWORK SETTINGS:
The access control panel MUST be configured with the proper network settings to operate. Contact the site’s IT personnel for the
corresponding settings and record the settings below. DHCP is not recommended because the IP address might inadvertently change
after power cycle or if the router is reset.
The SIP providers listed in this document are the currently known providers that will work with the IPAC unit. We recognize there are
many SIP providers and LiftMaster is not endorsing the use of any one particular SIP provider. The SIP providers are only listed
as a convenience for the installer.
Site Name:
Address:
Site Contact:
Phone Number:
Technical Support (IT) Contact:
Phone Number:
Survey By:
Survey Date:
Proposed Install date:
Internet service provider:
IP Address: ________ . ________ . ________ . ________
Netmask: ________ . ________ . ________ . ________
Gateway: ________ . ________ . ________ . ________
Primary DNS: ________ . ________ . ________ . ________
Secondary DNS: ________ . ________ . ________ . ________
Server Port:
SIP service provider:
Known compatible SIP providers: didlogic and phone.com
SIP domain:
SIP port (usually 6050):
SIP username:
SIP password:
1