LiftMaster J GT- Logic 4 User Manual

LiftMaster J Manual

Get LiftMaster J PDF manuals and user guides View all LiftMaster J manuals
Add to My Manuals
Save this manual to your list of manuals

LiftMaster J manual content summary:

  • LiftMaster J | GT- Logic 4 User Manual - Page 1
    USER'S GUIDE H, J, AND HJ T AND APT L 4 ogic L3 L3 GH GT THIS PRODUCT IS TO BE INSTALLED AND SERVICED BY A TRAINED DOOR SYSTEMS TECHNICIAN ONLY. Operators are shipped in C2 operating mode. Visit www.liftmaster.com to locate a professional installing dealer in your area. 2 YEAR WARRANTY
  • LiftMaster J | GT- Logic 4 User Manual - Page 2
    Congratulations on purchasing a quality, LiftMaster Logic 4 Commercial Door Operator. Your new operator is capable of operating up to 12 cycles per hour or 50 cycles per day. It is equipped with a built in radio receiver that is compatible with our existing 315 MHz product line as well as a Timer
  • LiftMaster J | GT- Logic 4 User Manual - Page 3
    until the door reaches the down limit, or is stopped in travel. At which time the operator enters the B2 mode. Compatible with 3-Button Station, 1-Button Station, 1 and 3-Button Remote Control. A 1-Button remote control in FSTS mode will open only with the Timer-To-Close, bypassing a programmed mid
  • LiftMaster J | GT- Logic 4 User Manual - Page 4
    allows you to add as many as 23 Security✚® remotes or dip switch remote controls. NOTE: The following programming requires a LiftMaster Monitored Entrapment Protection (LMEP) device. SINGLE BUTTON REMOTE CONTROL 1 MID SLS CLS ASE MOTOR DIRECTION Press and release the RADIO button (RADIO LED
  • LiftMaster J | GT- Logic 4 User Manual - Page 5
    push buttons or remote controls. permit anyone to cross path of closing door. TIMER-TO-CLOSE Feature: Timer automatically closes door after preset time. All 6. Press and release the TIMER button to complete programming. safety devices must be unobstructed. The OPEN/CLOSE button LEDs will
  • LiftMaster J | GT- Logic 4 User Manual - Page 6
    closed position if possible. 1 Pull down on the emergency release handle and raise or lower the door manually. PRECAUCIÓN TO RECONNECT DOOR ARM TO TROLLEY 2 The trolley will reconnect on the next UP or DOWN operation, either manually or by using the door control or remote. 1 N O T I C E 6 AD A
  • LiftMaster J | GT- Logic 4 User Manual - Page 7
    HJ This operator has provisions for manually operating the door in case of emergency or power failure. Refer to the appropriate instructions below for your model operator. MODEL H AND GH These operators are equipped with a manual hoist. An electrical interlock will disable the electrical controls
  • LiftMaster J | GT- Logic 4 User Manual - Page 8
    safety instructions included in this manual. • Be sure the owner or person(s) responsible for operation of the door have read and understand the safety instructions, know how to electrically operate the door in a safe manner and how to manually disconnect the door from the operator. 8 ADVERTENCIA
  • LiftMaster J | GT- Logic 4 User Manual - Page 9
    adjustment Operator or door requires adjustment Operator requires adjustment DOOR REVERSES UNEXPECTEDLY Entrapment protection device activated RADIO FUNCTIONALITY NO RESPONSE REMOTE CANNOT BE PROGRAMMED POOR RANGE Remote control is not programmed Low battery Low battery Low battery in remote
  • LiftMaster J | GT- Logic 4 User Manual - Page 10
    OPERATOR NOTES 10
  • LiftMaster J | GT- Logic 4 User Manual - Page 11
    enclosure with Maintenance Alert System. STOP Key Control Station: OPEN CLOSE Indoor flush mount, NEMA 1 with Stop button. STOP MOUNTING BRACKETS ENTRAPMENT PROTECTION DEVICES MONITORED CPS-UN4 Commercial Protector System®: Provides protection on doors up to 45' wide. NEMA-4 rated. CPS
  • LiftMaster J | GT- Logic 4 User Manual - Page 12
    01-35242 © 2010, The Chamberlain Group, Inc. All Rights Reserved
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
ogic
L
4
USER’S GUIDE
L3
GT
T AND APT
H, J, AND HJ
GH
A
L
E
R
T
S
Y
S
T
E
M
M
A
I
N
T
E
N
A
N
C
E
PATENT PENDING
The Maintenance Alert System™ allows the installer
to set an internal Maintenance Cycle Counter. The
Logic 4 operator incorporates a self-diagnostic
feature built into the (MAS) Maintenance Alert
System LED. An LED on the 3-button station will
signal when the set number of cycles/months is
reached or when the operator requires immediate
service.
THIS OPERATOR FEATURES THE ENHANCED
Radio Receiver
Built on Board
315MHz
NOT FOR RESIDENTIAL USE
Serial # Box
Installation Date
2 YEAR WARRANTY
THIS PRODUCT IS TO BE
INSTALLED AND SERVICED
BY A TRAINED DOOR
SYSTEMS TECHNICIAN
ONLY.
Operators are shipped in C2
operating mode.
Visit www.liftmaster.com to locate
a professional installing dealer in
your area.
CONTACT INFORMATION
www.liftmaster.com