NEC NP-UM351W NP03Wi Software Manual
NEC NP-UM351W Manual
 |
View all NEC NP-UM351W manuals
Add to My Manuals
Save this manual to your list of manuals |
NEC NP-UM351W manual content summary:
- NEC NP-UM351W | NP03Wi Software Manual - Page 1
NP03Wi Interactive White Board Kit SOFTWARE MANUAL This manual describes installation and operation procedures of the driver / the calibration software for NP03Wi Interactive White Board Kit 1 - NEC NP-UM351W | NP03Wi Software Manual - Page 2
software, all indications are displayed in English How to install this software 1. Download the software.ɹ Access to our projector support page in our website with the below URL: http://www.nec-display.com/dl/en/index.html Find the software for the Interactive White Board Kit, NP03Wi, download and - NEC NP-UM351W | NP03Wi Software Manual - Page 3
the terms in the License Agreementʡand click ʠNext ʼʡ Displays the selection screen of the installation destination folder. 5. Click [Next>]. After that, follow the displayed instructions to complete installation. When the installation is complete, an IWB icon is added to the desktop. 3 - NEC NP-UM351W | NP03Wi Software Manual - Page 4
the start menu, and double-click [Add or Remove Programs]. 2. Right-click [NP03Wi IWB] and click [Uninstall] in the list. After that, follow the displayed instructions to complete uninstallation. 3. When uninstallation is completed properly, reboot the computer. 4 - NEC NP-UM351W | NP03Wi Software Manual - Page 5
message is displayed on. ClickʠOKʡand follow the displayed instructions for the sequel operations. When driver installation is completed properly, trouble shooting is displayed on Close IWB Setup Menu. * The software will continue to run. Switch to the troubleshooting screen Perform manual - NEC NP-UM351W | NP03Wi Software Manual - Page 6
preferred. Manual calibration Manually calibrate the stylus pen position. Recommend this for installing the projector permanently or : • If the message in below is displayed on the screen, refer to the Troubleshooting on page 7 and check if the screen is installed within the recognition area of the - NEC NP-UM351W | NP03Wi Software Manual - Page 7
WhenʠAuto Runʡin the troubleshooting screen is checked, the software starts automatically when the computer is started up. • Drawing software is required to use the interactive white board function. Drawing software cannot be downloaded from our projector support page, prepare commercially available - NEC NP-UM351W | NP03Wi Software Manual - Page 8
corners of the projection screen by the stylus pen. A red square is indicated on the troubleshooting screen and it can be checked all area of the screen surface is in the camera recognition ? • If it does not solve the problem by performing automatic calibration, try to perform manual calibration. 8
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
 |
 |
1
NP03Wi Interactive White Board Kit
SOFTWARE MANUAL
This manual describes installation and
operation procedures of the driver / the
calibration software for NP03Wi Interactive
White Board Kit