Netgear M4100-D12G CLI Manual - Page 95
storm-control broadcast
View all Netgear M4100-D12G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 95 highlights
ProSafe M4100 and M7100 Managed Switches rate kbps. For example, if the configured limit is 10%, this is converted to ~25000 pps, and this pps limit is set in forwarding plane (hardware). You get the approximate desired output when 512bytes packets are used. storm-control broadcast Use this command to enable broadcast storm recovery mode for a specific interface. If the mode is enabled, broadcast storm recovery is active and, if the rate of L2 broadcast traffic ingressing on an interface increases beyond the configured threshold, the traffic will be dropped. Therefore, the rate of broadcast traffic will be limited to the configured threshold. Default Format Mode enabled storm-control broadcast Interface Config no storm-control broadcast Use this command to disable broadcast storm recovery mode for a specific interface. Format Mode no storm-control broadcast Interface Config storm-control broadcast level Use this command to configure the broadcast storm recovery threshold for an interface as a percentage of link speed and enable broadcast storm recovery. If the mode is enabled, broadcast storm recovery is active, and if the rate of L2 broadcast traffic ingressing on an interface increases beyond the configured threshold, the traffic is dropped. Therefore, the rate of broadcast traffic is limited to the configured threshold. If the 'shutdown' option is selected, and the broadcast traffic increases beyond the threshold, the interface shuts down instead of dropping packets. To recover the port, issue 'no shutdown' under the port manually. Default Format Mode 5 storm-control broadcast level {action [ratelimit | shutdown]} Interface Config Switching Commands 95