Pyle PDWM4560 Instruction Manual
Pyle PDWM4560 Manual
 |
View all Pyle PDWM4560 manuals
Add to My Manuals
Save this manual to your list of manuals |
Pyle PDWM4560 manual content summary:
- Pyle PDWM4560 | Instruction Manual - Page 1
PDWM4520 PDWM4540 PDWM4560 PDWM4520 - PDWM4540 - PDWM4560 Wireless Microphone System - Pyle PDWM4560 | Instruction Manual - Page 2
ACHIEVING MAXIMUM PERFORMANCE 9 12. TROUBLESHOOTING 10 12. SPECIFICATIONS 11 SYSTEM receiver X1 5. Battery 1.5V X8 6. User guide X1 1 www.PyleUSA.com FOREWORD This professional a wireless system, and the excellent quality. This manual covers each of the Series system: The VocalArtist-UHF - Pyle PDWM4560 | Instruction Manual - Page 3
FOUR CHANNEL RECEIVER FEATURES MICROPHONE-TRANSMITTER FEATURES 1. Power Button: Power ON/OFF the receiver. 2. Power Indicator: Indicates the power ON/OFF. 3. "AF"Audio Level lndicator: Indicates the wireless system audio signal level. 4. Volume Knob: Adjust the volume output of receiver. 5. "RF" - Pyle PDWM4560 | Instruction Manual - Page 4
BODY-PACK TRANSMITTER FEATURES TRANSMITTER BATTERY INSTALLATION 1. Battery Installation of Handheld Microphone: Open the battery cover. Insert the supplied batteries into battery jar in polarity and cover the battery cover. 1. Power and Audio Mute Switch. 2. Antenna: Transmit the RF signal of - Pyle PDWM4560 | Instruction Manual - Page 5
BODYPACK TRANSMITTER CONNECTION 1. Lavalier Microphone Connection: Connect the connector of supplied lavalier microphone to the connecting jack of transmitter (shown as below) Set the transmitter work state in wireless lavalier system (L). SYSTEM CONNECTION 1. Receiver Power Connection: Connect the - Pyle PDWM4560 | Instruction Manual - Page 6
before Performance or Presentation. If dead spots are found, adjust location of receiver. If dead spots remain, mark spots and avoid. TROUBLESHOOTING PROBLEM No Sound No Sound No Sound No Sound INDICATOR STATUS SOLUTION Red transmitter indicator is not ashing Slide transmitter POWER ON/OFF - Pyle PDWM4560 | Instruction Manual - Page 7
SYSTEM SPECIFICATIONS • Wireless Operating Frequency Range: Approximately 573.0 - 597.8 MHz (Available frequencies depend on applicable regulations in country where system is used). • Operating Range: 50m (approximately 164ft) under typical conditions • Audio Frequency Response: 100 to 18,000Hz, ± - Pyle PDWM4560 | Instruction Manual - Page 8
Pyle PDWM4520 Wireless Microphone System, UHF Quad Channel Fixed Frequency, 4 Handheld Microphones, Rack Mountable UHF Band Receiver System • Quad Frequency Channel Design (Channel1, 2, 3, 4) • Broad Frequency Response Range & Low Distortion • High Signal/Noise Ratio Performance • RF Signal &AF - Pyle PDWM4560 | Instruction Manual - Page 9
• Battery Powered: 2 x 'AA' Batteries (Included) • Batteries Included • Weight: 180g Transmitters: • RF Power Output: >10dBm • Modulation Type: FM • Max. Deviation:+/- 40kHz • Nominal Power Current: 53dBc • Battery Powered: 2 x 'AA' Batteries (Included) Batteries Included
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
 |
 |
PDWM4520
PDWM4540
PDWM4560
Wireless Microphone System
PDWM4520 - PDWM4540 - PDWM4560