Pyle PDWM94 PDWM94 Manual 1

Pyle PDWM94 Manual

Pyle PDWM94 manual content summary:

  • Pyle PDWM94 | PDWM94 Manual 1 - Page 1
    PDWM94 WIRELESS MICROPHONE AND RECEIVER OPERATING INSTRUCTIONS It is very happy that you have this professional wireless microphone of good quality which will that, plug the receiver into the input socket for microphone of amplifier and it is ready for operation. 2. When you need temporary stop during singing and
  • 1

WIRELESS MICROPHONE AND RECEIVER
OPERATING INSTRUCTIONS
HOW DO YOU OPERATE IT?
ATTENTIONS:
SPECIFICATIONS:
ACCESSORIES:
It is very happy that you have this professional wireless microphone
of good quality which will bring you into a world where you can sing
happily and freely to your heart's content so that you enjoy it
admiringly
Screw off the housing, insert a battery (size AA) with the correct polarity and
screw on the housing before inserting the telescopic antenna and set the
switch to the ON position. The pilot lamp is on at this time. Insert another
battery (size AAA) into the receiver with the correct
polarity. Set the switch
of receiver to ON position, then the pilot lamp is on that indicate a good
condition. After that, plug the receiver into the input socket for microphone of
amplifier and it is ready for operation.
When you need temporary stop during singing and you don't want the
microphone to pick up any other sound, you may set the switch to the middle
(MIC) position. Now, the lamp is still on but your microphone doesn't transmit
any sound.
Use it as wired microphone:
Take out the battery from the microphone, connect the wire to the
microphone and set the switch to MIC position.
Microphone sensitivity
Directivity
Frequency response
Out put impedance
Operating voltage
Effective distance
-72dB
Undirectional
100 to 10,000Hz
600 ohm
1.5 V DC
15 to 30 m
1 Receiver
1 Wireless antenna
1 Wire for wired microphone
If acoustic quality and volume are abnormal or receiving distance is shorted,
the batteries in wireless microphone and receiver should be replaced, If
thereafter still not in normal operation, you can carefully trim the frequency of
receiver with a screwdriver to become normal operation.
If your microphone isn't used for a long period, the battery should be taken
out to avoid its deterioration and the damage of components.
If two wireless microphones are used at the same time, you must use them
1.
2.
3.
1.
2.
3.
PDWM94