Pyle PIH30R PIH20 Manual 1

iPod wireless headphone

PIH20 / PIH30R

INSTRUCTIONS

The wireless Headphone

PIH20/PIH30R

for iPod use advanced 915MHz ultra high frequency technology for

crystal clear audio.

This wireless headphone system comprises of a wireless headphone and an iPod

dock transmitter which also functions as an 'easy-charge' cradle and docking station for iPods. The

PIH20/PIH30R utilizes RF wireless audio transmission, offering an effective range of 150 feet (line of

sight), and can serve up to several headphones.

Auxiliary connection lets you listen to non-docking iPod models, MP3 /CD/DVD/TV or any audio systems.

PIH30R

offers a remote control, so you can adjust the volume, play, pause, mute or select tracks without

touching your iPod or iPhone.

Please take a few moments to read these instructions carefully, as we want you to enjoy your new Pyle

product quickly and to the full.

System components and connections

- 1 headphone - 1 iPod transmitter - 1 remote control (included with PIH30R) - 1 power supply

- 1 3.5mm stereo jack detachable audio cable - 1 instruction manual - 1 Warranty letter

Where to place the transmitter

Do not place the transmitter close to metal objects such as shelf bars, reinforced concrete walls, etc.

If there is no audio signal for about 4 minutes, the transmitter automatically switches off. The transmitter

is now in stand-by mode, its power consumption is very low so that it can remain connected to the

mains.

Pressing the headphone receiver on/off

The TUNE/ON/OFF button is on the right earpiece.

Make sure to turn off the headphones after each use.

Adjusting the volume

Set the volume of your sound source to a medium value.

With some devices, the volume for the headphone

output can be regulated separately. Use the

VOLUME

control on the right earpiece to adjust the headphones

volume.

Changing the receiver channel

Press the

ON/OFF

button on the right earpiece until you

can hear the audio signal loud and clear. Your

headphones start on

1CH.

Tap the power button to set

to

2CH

. Tap again for

3CH

. Tapping again will reset to

1CH

, and so on.

Changing the transmission channel

To avoid interference caused by the simultaneous

operation of several transmitters, select a different channel on each transmitter. Depending on the

system variant, two or three switchable transmission channels are available.