Pyle PINV6 PINV4 Manual 1
Pyle PINV6 Manual
 |
View all Pyle PINV6 manuals
Add to My Manuals
Save this manual to your list of manuals |
Pyle PINV6 manual content summary:
- Pyle PINV6 | PINV4 Manual 1 - Page 1
PINV4 PINV5 PINV6 OWNER'S MANUAL POWER INVERTER PINV4 600WATT PINV5 800WATT PINV6 1000WATT www.pyleaudio.com - Pyle PINV6 | PINV4 Manual 1 - Page 2
Thank you for purchasing the PYLE View DC to AC Power Inverter. The PINV4/PINV5/PINV6 will deliver an efficient loss of life. -WARNING • Shock Hazard. Keep away from children. • The PINV4 / PINV5 / PINV6 Generates the same potentially lethal AC power as normal household wall outlet. Treat it with - Pyle PINV6 | PINV4 Manual 1 - Page 3
FEATURES PINV4 / PINV5 / PINV6 1. AC OUTLET 2. ON/OFF SWITCH 3. POWER ON LED 4. PROTECTION LED 5. BINDING POST TERMINAL 2 - Pyle PINV6 | PINV4 Manual 1 - Page 4
fumes are present. C. Connect the BLACK cable to the black post (-) and RED cable to the red post (+) on the rear of the PINV4/ PINV5/PINV6. Then connect the BLACK battery chip to the NEGATIVE (-) terminal and RED battery chip to the POSITIVE (+) terminal of the battery. The reverse polarity - Pyle PINV6 | PINV4 Manual 1 - Page 5
AC power at the AC outlet when switched ON. It also acts as a manual reset for overload, low battery voltage and overheat fault conditions. Reset occurs by Single and dual AC outlets are provided on one end of the PINV4, PINV5 and PINV6, make sure of the power consumption required before plug in: - Pyle PINV6 | PINV4 Manual 1 - Page 6
BATTERY OPERATING TIME The vehicle batteries are not intended for constant deep discharge, they are designed to provide brief periods of very high current needed for engine starting. It is strongly recommended to start the vehicle every hour or two to recharge battery before its capacity drops too - Pyle PINV6 | PINV4 Manual 1 - Page 7
TROUBLE SHOOTING SYMPTOM A: NO AC POWER OUTPUT, THE RED LED LIGHTS. POSSIBLE CAUSES SUGGESTION The connected AC products are rated at more than 600 Watts Use the product with a total power rating (PINV4) , 800 Watts (PINV5) or 1000 Watts (PINV6), the less than 600 Watts (PINV4) , 800 Watts - Pyle PINV6 | PINV4 Manual 1 - Page 8
voltage is too low below 10V DC The inverter is overload SUGGESTION Recharge battery Reduce load to 600 Watts (PINV4) , 800 Watts (PINV5) and 1000 Watts (PINV6) maximum to maintain regulation. SYMPTOM D: THE LOW BATTERY IS MEASURED POSSIBLE CAUSES The poor battery condition Inadequate power - Pyle PINV6 | PINV4 Manual 1 - Page 9
voltage range 10-15 Volts DC Maximum Continuous AC output power 600 Watts (PINV4) ...800 Watts (PINV5) ...1000 Watts (PINV6) Maximum AC output surge power 1200 Watts (PINV4) ...1600 Watts (PINV5) ...2000 Watts (PINV6) AC output frequency 60 Hz +/- 2 Hz AC output waveform modified sine wave No
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
 |
 |
www.pyleaudio.com
PINV4
PINV5
PINV6
PINV4
600WATT
PINV5
800WATT
PINV6
1000WATT
OWNER’S MANUAL
POWER INVERTER