Pyle PLMR89WW PLMR89WW Manual 1

Pyle PLMR89WW Manual

Get Pyle PLMR89WW PDF manuals and user guides View all Pyle PLMR89WW manuals
Add to My Manuals
Save this manual to your list of manuals

Pyle PLMR89WW manual content summary:

  • Pyle PLMR89WW | PLMR89WW Manual 1 - Page 1
    PLMR89WW OWNER'S MANUAL Mobile Audio System 7/ MOD 8/ 9/ AUX IN RESET VOL + SEL VOL - CH1 1 CH2 2INT CH3 3RPT CH4 4RDM CH5 5DIR- CH6 6DIR+ AS/PS BAND DSP/0 MUTE CH7/EQ www.pyleaudio.com 1
  • Pyle PLMR89WW | PLMR89WW Manual 1 - Page 2
    3 Take out screw before installation ..........3 DIN Front-Mount (Method A 3 Installing the unit 3 Removing the unit 4 DIN Rear-Mount (Method B 4 storing& program scanning 8 Station storing 8 USB play operation 8 Supported MP3/WMA decoding modes 9 SD/MMC operation 9 Remote Control 10
  • Pyle PLMR89WW | PLMR89WW Manual 1 - Page 3
    interfere with the normal driving function of the driver.  Before finally installing the unit, connect the wiring temporarily and make sure it is all unit. Then slide the sleeve off the back of the unit.  Avoid installing the unit where it would be subject to high temperature, such as from direct
  • Pyle PLMR89WW | PLMR89WW Manual 1 - Page 4
    also helps ensure proper electrical grounding of the unit. Note to install the short threading terminal of the mounting bolt to the back of MOUNT (Method B) If your vehicle is a Nissan, Toyota, follow these mounting instructions. Use the screw holes marked T (Toyota), N (Nissan) located on both
  • Pyle PLMR89WW | PLMR89WW Manual 1 - Page 5
    INSTALLATION Side View showing T, N Screw Screw Hook Dashboard or Console To fasten the unit to the factory radio mounting brackets. 1. Use a screwdriver to tighten the screws (5x5mm) on each side. Note: the outer trim ring, sleeve and the metal strap are not used for method B installation. 5
  • Pyle PLMR89WW | PLMR89WW Manual 1 - Page 6
    WIRING CONNECTION 6
  • Pyle PLMR89WW | PLMR89WW Manual 1 - Page 7
    button (20) must be activated with either a ballpoint pen or thin metal object. The RESET button is to be activated for the following reasons: - Initial installation of the unit when all wiring is completed. - All the function buttons do not operate. - Error symbol on the display. MUTE 7
  • Pyle PLMR89WW | PLMR89WW Manual 1 - Page 8
    to activate automatic seek function. Press for several seconds until "MANUAL" appears on the display, the manual tuning mode is selected. If both buttons have not been pressed operation please refer to the following instruction. SELECTING SONGS IN SINGLE STEP Press / button (2) to move to the 8
  • Pyle PLMR89WW | PLMR89WW Manual 1 - Page 9
    GENERAL OPERATION previous song or the following song. Track number shows on display. SELECTING DIRECTORY UP/DOWN Press DIR+ button (13) or DIR- button (14) to select directory downward or upward. If the MP3 disc does not contain any directory, there is no function of pressing DIR- button (14) or
  • Pyle PLMR89WW | PLMR89WW Manual 1 - Page 10
    REMOTE CONTROL HANDSET(OPTIONAL) FUNCTION KEY & CONTROL 1. POWER Power ON/OFF Button 2. MODE Mode Botton(S,T,U,7,For MP3/WMA Operation) 3. TUNE/SKIP (8) Tune/SKIP Down Button(V,W,X,8 For MP3/WMA Operation) 4. 7/BND Band Select Button(When pressed shortly) 5. SCN Scanning Button(D,E,F,2
  • Pyle PLMR89WW | PLMR89WW Manual 1 - Page 11
    SPECIFICATION GENERAL Power Supply Requirements : DC 12 Volts, Negative Ground Chassis Dimensions : 178 (W) x 107 (D) x 50 (H) Tone Controls - Bass (at 100 Hz) : ±10 dB - Treble (at 10 kHz) : ±10 dB Maximum Output Power - Version Y : 4x50 watts Current Drain - 15 Ampere (max.) (For
  • Pyle PLMR89WW | PLMR89WW Manual 1 - Page 12
    TROUBLE SHOOTING Before going through the checklist, check wiring connection. If any of the problems persist after checklist has been made, consult your nearest service dealer. Symptom No power. Cause The car Press the reset button. Insert the antenna cable firmly. Select a station manually. 12
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
1
PLMR89WW
OWNER’S MANUAL
Mobile Audio System
www.pyleaudio.com
VOL +
VOL -
CH7/EQ
MUTE
RESET
AS/PS
DSP/0
SEL
BAND
AUX
IN
7 MOD
/
9/
1
8/
2
INT
3
RPT
4
RDM
5
DIR-
6
DIR+
CH1
CH2
CH3
CH4
CH5
CH6