Pyle PNVR450 PNVR450 Manual 1

Pyle PNVR450 Manual

Get Pyle PNVR450 PDF manuals and user guides View all Pyle PNVR450 manuals
Add to My Manuals
Save this manual to your list of manuals

Pyle PNVR450 manual content summary:

  • Pyle PNVR450 | PNVR450 Manual 1 - Page 1
    PNVR300 PNVR450 PNVR800 OWNER'S MANUAL POWER INVERTER PNVR300 150WATT PNVR450 220WATT PNVR800 400WATT www.pyleaudio.com
  • Pyle PNVR450 | PNVR450 Manual 1 - Page 2
    INTRODUCTION Thank you for purchasing the PYLE DC to AC Power Inverter. The PNVR300/PNVR450/PNVR800 will deliver an efficient power to a wide variety of household AC products or electronic appliance reliably from the 12 volt outlet in your vehicle or boat, or directly from a 12 Volt battery to serve
  • Pyle PNVR450 | PNVR450 Manual 1 - Page 3
    FEATURES PNVR300/PNVR450/PNVR800 1.AC OUTLET 2. ON/OFF SWITCH 3. POWER ON LED 4. PROTECTION LED 5. LIGHTER PLUG @ @ PROTECTlON D D OUTPUT AC 11DV ® @ 2
  • Pyle PNVR450 | PNVR450 Manual 1 - Page 4
    OPERATION • CAUTION: DO NOT USE THIS INVERTER WITH THE FOLLOWING: • Small battery operated appliances such as RECHARGEABLE FLASHLIGHTS,SOME RECHARGEABLE SHAVERS and NIGHT LIGHTS that are plugged directly into as RECEPTACLE TO RECHARGE • BATIERY CHARGERS used with certain power tool battery pecks.
  • Pyle PNVR450 | PNVR450 Manual 1 - Page 5
    when switched ON. It also acts as a manual reset for overload, low battery voltage and overheat provided on one end of the PNVR300, PNVR450 and PNVR800, make sure of the power designed for connection directly to standard electrical and electronic equipment. • Do not connect the inverter to
  • Pyle PNVR450 | PNVR450 Manual 1 - Page 6
    BATTERY OPERATING TIME The operating time of battery will vary depending on the charge level of the battery, its capacity and the power level drawn by the particular AC load. The vehicle batteries are not intended for constant deep discharge, they are designed to provide brief periods of very high
  • Pyle PNVR450 | PNVR450 Manual 1 - Page 7
    TROUBLE SHOOTING SYMPTOM A: NO AC POWER OUTPUT, THE RED LED LIGHTS. POSSIBLE CAUSES SUGGESTION The connected AC products are rated at more than 150 Watts Use the product with a total power rating (PNVR300) , 220 Watts (PNVR450) or 400 Watts (PNVRBOO), less than t50 Watts (PNVR300), 220 Watts
  • Pyle PNVR450 | PNVR450 Manual 1 - Page 8
    voltage is too low below 10V DC The inverter is overload SUGGESTION Recharge battery Reduce load to t 50 Watts (PNVR300) , 220 Watts (PNVR450) and 400 Watts (PNVR800) maximum to maintain regulation. SYMPTOM D: THE LOW BATTERY IS MEASURED POSSIBLE CAUSES The poor battery condition Inadequate power
  • Pyle PNVR450 | PNVR450 Manual 1 - Page 9
    voltage range 10-15 Volts DC Maximum Continuous AC output power 150 Watts (PNVR300 220 Watts (PNVR450 400 Watts (PNVR800) Maximum AC output surge power 300 Watts (PNVR300 440 Watts (PNVR450 BOO Watts (PNVR800) AC output frequency 60Hz+/-2Hz AC output waveform modified sine wave No load
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
PNVR300
PNVR450
PNVR800
OWNER'S
MANUAL
POWER
INVERTER
PNVR300 150WATT
PNVR450 220WATT
PNVR800 400WATT
www.pyleaudio.com