Pyle UPLSD131BT User Manual

Pyle UPLSD131BT Manual

Pyle UPLSD131BT manual content summary:

  • Pyle UPLSD131BT | User Manual - Page 1
    PLSD131BT Motorized Foldout Monitor Holder 13.3 Inch Million Multi-color Illumination TFT Touch Screen Detachable Control Panel Remote Control Digital Video Disc Player Control Panel USB Port and AUX Input SD/MMC Card Slot AM/FM-RDS Digital PLL Tuning Radio BT Compatible USER MANUAL
  • Pyle UPLSD131BT | User Manual - Page 2
    To ensure safety while driving and to comply with laws, drivers should not watch video or operate the video device while driving.
  • Pyle UPLSD131BT | User Manual - Page 3
    RDS function 21 Media Operation 23 Basic Operation 24 Selecting Play Mode 24 On-Screen Display Function 25 Digital Video Special Function........26 Multi-Subtitle Language function.......26 Multi USB Operation 32 Card Operation 32 SWC Operation 33 Specification 34 Troubleshooting 35 -1-
  • Pyle UPLSD131BT | User Manual - Page 4
    DIGITAL VIDEO PLAYER . Before operating the unit, read this manual thoroughly and keep it handy for future reference . To , thinner, commercially available cleaners or antistatic spray . -Do not use alcohol to clean the screen . If your car was parked in a cold or hot place, the picture may not
  • Pyle UPLSD131BT | User Manual - Page 5
    . BE SURE TO OPERATE THE DIGITAL VIDEO PLAYER CORRECTLY AS INSTRUCTED. USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER HAZARDOUS RADIATION EXPOSURE.DO NOT OPEN COVERS AND DO NOT REPAIR YOURSELF. REFER SERVICING TO QUALIFIED PERSONNEL. WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC
  • Pyle UPLSD131BT | User Manual - Page 6
    Note Disc formats supported by this player Digital Digital Video Video VCD VCD Audio and Video Disc size 12 cm Audio and Video Disc size 12 cm unusable) depending on your handle it and conditions in the usage environment. Note these scratches are not an indication of any problem with the player
  • Pyle UPLSD131BT | User Manual - Page 7
    Installation NOTES: Choose the mounting location where the unit will not interfere with the normal driving function of the driver. Before finally installing the unit, connect the wiring temporarily and make sure it is all connected up properly and the unit and the system work properly. Use only the
  • Pyle UPLSD131BT | User Manual - Page 8
    Installation INSTALLATION STEPS 1. Remove the chassis from Slide Bracket Housing; 1) Press the REL button to release the control panel ; REL button 2) Hold the right side of the control panel to pull it rightwards a little and then to you for removing it ; 1 2 3) Remove the PLASTIC FRAME from
  • Pyle UPLSD131BT | User Manual - Page 9
    Installation 2) Attaching the control panel onto the chassis; (1) Insert the left side of the control panel into the hollow of the chassis . (NOTE : the "bulge" point on the control panel must be attached into the hollow of the chassis .) (2) Gently push the right side of the control panel till you
  • Pyle UPLSD131BT | User Manual - Page 10
    Installation Installating the unit DASH BOARD HEX NUT SPRING WASHER PLAIN WASHER TAPPING SCREW SCREWDRIVER METAL MOUNTING STRAP CONSOLE SLIDE BRACKET HOUSING HEX BOLT TABS KEY PLATE KEY PLATE PLASTIC TRIM OUT If you want to take CHASSIS out of the SLIDE BRACKET HOUSING, first remove the
  • Pyle UPLSD131BT | User Manual - Page 11
    Installation Installing the monitor. 1) Press the OPEN/MONITOR-ANGLE button to slide the monitor holder out and stand it up. 2) Insert the 2 bulges of the monitor into the 2 hollows of the monitor holder and flip up the monitor, then push the top middle part of the monitor to make the monitor attach
  • Pyle UPLSD131BT | User Manual - Page 12
    Electric Connection WIRING CONNECTION RCH IN RED VIDEO OUT(2) YELLOW AV IN VIDEO IN YELLOW LCH IN WHITE REAR OUTPUT CABLE RCH RED LCH WHITE SUBWOOFER GREY REAR CAMERA INPUT YELLOW FRONT RCA OUTPUT CABLE FRONT RCA RED R VIDEO OUT YELLOW FRONT RCA WHITE L RADIO ANTENNA JACK ISO CONNECTOR
  • Pyle UPLSD131BT | User Manual - Page 13
    Remote Control 15 17 7 19 2 13 22 6 14 24 18 11 10 4 8 MODE MUTE PLAY/PAUSE STOP REDIAL ZOOM MO/ST PAIR LOUD MENU EQ CLK LO/DX OSD BAND ENTER
  • Pyle UPLSD131BT | User Manual - Page 14
    level. 12 / / / Press to navigate the various menus present in the product. Menu Press this button briefly to display the root level directory of a 13 SubWoofer Digital Video disc. Press and hold this button to switch SWF FREQ ( ) between 80HZ, 120HZ and 160HZ. BAND 14 (OSD) In Radio mode
  • Pyle UPLSD131BT | User Manual - Page 15
    arrow (See 1 )And then Remove the battery holder as the direction indicated by the arrow (See 2 ). 2.Replace the battery Set a new battery property with (+)side up as illustrated (See 3 ). 3.Insert the battery holder. please remove this foil so that the remote control is ready for operation . -13-
  • Pyle UPLSD131BT | User Manual - Page 16
    Basic Operation Main Menu Operation In many modes, touch the icon or touch the range to enter the main menu, the message like following as below. 10:00AM (4) GENERAL CLOCK AUDIO VIDEO Setup interface 1 LANGUAGE ILLUMINATION COLOR CALIBRATION (1) (2) (3) (5) Setup interface 2 ADJUSTABLE
  • Pyle UPLSD131BT | User Manual - Page 17
    16:9 4:3 Letter Box Wide (For 16:9 TV) Select when a wide-screen TV set is connected. RATING Select to turn Parental Control on or off. The then turn to rating then you can setting as follow: KID SAFE -> G -> PG -> PG-13 -> PG R -> R ->NC-17 -> ADULT RADIO DUAL: touch to select stereo or mono.
  • Pyle UPLSD131BT | User Manual - Page 18
    Basic Operation AUDIO SETUP Touch the audio to turn to audio quality adjustment. AUDIO BASS TREBLE SUBWOOFER EQ ... USER audio setup interface1 AUDIO LOUDNESS FADER/BLANCE OFF ... audio setup interface2 TREBLE: -7 to +7 Adjust treble level . VIDEO SETUP COLOR BRIGHTNESS CONTRAST TINT
  • Pyle UPLSD131BT | User Manual - Page 19
    Basic Operation Reset Factory Settings RESET button is placed on the housing and must be activated with either a ballpoint pen or thin metal object. ALTERNATE AUDIO SOURCE On the front panel of the unit , there is an AUX IN jack, to connect analogue replay devices. Use this jack to replay sound of
  • Pyle UPLSD131BT | User Manual - Page 20
    /MODE BUTTON 4. >>|/ BUTTON 5. TA/AF BUTTON 6. PAIR/BAND BUTTON 7. MUTE BUTTON 8. >||/CH1-6 BUTTON 9. REL BUTTON -18- 10. |
  • Pyle UPLSD131BT | User Manual - Page 21
    Control Panel Same functions in any work source 1. POWER/MODE button In power off mode, pressing POWER/MODE button on remote control or pressing POWER/MODE button on control panel powers on main unit. In power on mode, long pressing POWER/MODE button on control panel or on remote control or touch
  • Pyle UPLSD131BT | User Manual - Page 22
    .10 101.70 107.9 98.10 100.8 Selecting The Frequency Band Touch the screen of " BAND " section repeatedly to select the band , the message will show to select the MONO or STEREO mode . Start Searching For a Station Manual Search During Radio mode, briefly touch " " to increase frequency by one
  • Pyle UPLSD131BT | User Manual - Page 23
    storage locations . Then the station of the first storage location is set . Scan Function In Radio mode, briefly touch the " " section on the touch screen , the radio briefly plays all the preset stations of the frequency band . RDS FUNCTION REGION SET Touch to switch the REGION function ON and OFF
  • Pyle UPLSD131BT | User Manual - Page 24
    for a short time for a short time and the message "NEW FREQUENCY " is displayed for one or two seconds. PTY FUNCTION In Radio mode, touch screen of "PTY" range to select the Program type . PTY Selection of the program type besides the stations name, some FM stations also transmit information on
  • Pyle UPLSD131BT | User Manual - Page 25
    Touch Screen Operation Media Operation In audio play mode, the message will display as below : (When Parking Brake is applied .) To skip the next track To skip
  • Pyle UPLSD131BT | User Manual - Page 26
    rotate an image to left . Press RIGHT to rotate an image to right . SELECTING PLAY MODES Rapid Forward/Rapid Reverse During DISC playback, touch the screen of " / " range the speed of rapid forward/reverse changes according to the disc as follow: Digital Video/VCD/CD/MP3: Normal Playback 2x 4x 8x
  • Pyle UPLSD131BT | User Manual - Page 27
    Movie or PHOTO . When it is on, it will display the information such as: F 001/003 T 001/001 3). RDM(RANDOM) FUNCTION During DISC playback, touch screen of " " section ( press the RDM button on the remote control to play in random. Each play mode the order is different . (Depend on the disc
  • Pyle UPLSD131BT | User Manual - Page 28
    favour by touching the numberic buttons , then touch the OK button to confirm . For VCD/CD: during playback, touch the AUDIO section of the touch screen or Press AUDIO on the remote . It is possible to switch the sound between monaural and stereo sound. MONO LEFT MONO RIGHT STEREO MIX-MONO
  • Pyle UPLSD131BT | User Manual - Page 29
    of radio, CD, AUX IN or BT music, the logo BT flashes in the touch screen. * During the use of the BT device named "BC-HF-V03" as a hands- Dial with mobile phone directly; (2)Dial with BT Phone, remote control, or on touch screen; a. Touch the BT PHONE icon in home menu or touch the to turn to BT
  • Pyle UPLSD131BT | User Manual - Page 30
    Touch Screen Operation b. Use the number icons or buttons to input your desired phone number; * When inputting a wrong digit, use icon or < button to delete it. c. After
  • Pyle UPLSD131BT | User Manual - Page 31
    Touch Screen Operation Mute function To select the Equalizer mode To decrease the volume level To enables the user to stream audio from their device. 3) The BT device of the car A/V system supports AVRCP, so these icons on the BT Music interface except BT Music and their corresponding buttons on
  • Pyle UPLSD131BT | User Manual - Page 32
    Touch Screen Operation AUX Operation On the front panel of this unit, there is an AUX through the loudspeakers . The function of the icons as follow: Tap to mute the sound. 2). In radio mode, touch the screen of " " ICON to enter the main menu, touch the " AUX " ICON to enter the AUX IN mode . Tap
  • Pyle UPLSD131BT | User Manual - Page 33
    Touch Screen Operation AV Operation Please plug the on the back of the unit . Touch the AV IN icon to enter the AV IN mode.
  • Pyle UPLSD131BT | User Manual - Page 34
    , the device will be mounted and start playing automatically. Card OPERATION The unit can support playback MP3/WMA/ JPEG/MP4 and Divx format which are stored on SD memory cards . Please read the following instructions before you start using a memory card . Inserting the card as follow: Press REL
  • Pyle UPLSD131BT | User Manual - Page 35
    Touch Screen Operation STEERING WHEEL CONTROL Touch the SWC icon as follow to turn to steering wheel control . Then tap Assign and tap the button 1 and then
  • Pyle UPLSD131BT | User Manual - Page 36
    AM 530 to1710 KHz 450 KHz 40 dBu TFT Monitor: Monitor Screen Size: Color System: TV TV System TV Sensitivity 13.3 Inch Wide NTSC/PAL NTSC/PAL/SECAM 45dB uV@CH25 in average BT: BT specification: V1.2 Class 2 BT profile supported:
  • Pyle UPLSD131BT | User Manual - Page 37
    Troubleshooting Before going through the check list, check wiring connection. If any of the problems persist after check list has been made, consult your nearest service dealer. SYMPTOM CAUSE SOLUTION No power The car ignition switch is not on The fuse is blown If the power supply is properly
  • Pyle UPLSD131BT | User Manual - Page 38
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38