Ryobi AC04141B Operation Manual

Ryobi AC04141B Manual

Get Ryobi AC04141B PDF manuals and user guides View all Ryobi AC04141B manuals
Add to My Manuals
Save this manual to your list of manuals

Ryobi AC04141B manual content summary:

  • Ryobi AC04141B | Operation Manual - Page 1
    UNIVERSAL PRO CUT II™ STRING HEAD AC04141B WARNING: To reduce the risk of injury, user must read and understand the operator's manual for their string trimmer and this instruction sheet. Always wear eye protection marked to comply with Z87.1 Ensure compatibility and fit before using this accessory
  • Ryobi AC04141B | Operation Manual - Page 2
    the cutter on the grass shield before operating. If the string head does not fit with any of the adaptors or nuts s­ upplied, contact Customer Service at 1-800-860-4050 for assistance. Craftsman® is a registered trademark of Sears, Roebuck and Co. Yard Machine®, Yard-Man®, Bolens®, MTD®, Troy-Bilt
  • Ryobi AC04141B | Operation Manual - Page 3
    À LIGNE DE COUPE DE PRO CUT II™ AC04141B AVERTISSEMENT : Pour réduire les risques de blessures, l'utilisateur doit lire et veiller à bien comprendre le manuel d'utilisation du taille-bordures ainsi que cette feuille d'instruction. Toujours porter une protection oculaire certifiée conforme
  • Ryobi AC04141B | Operation Manual - Page 4
    entre en contact avec le couteau du déflecteur. Si la tête de coupe n'est compatible avec aucun des adaptateurs ou écrous fournis, communiquer avec le service à la clientèle au 1 800 860-4050 afin d'obtenir de l'aide. Craftsman® est une marque déposée de Sears, Roebuck and Co. Yard Machine®, Yard
  • Ryobi AC04141B | Operation Manual - Page 5
    HILO DE PRO CUT II™ AC04141B ADVERTENCIA: Para reducir el riesgo de lesiones, el usuario debe leer y comprender el manual del operador de la recortadora o si falta alguna pieza. Cuando se utilizan las recortadoras de hilo RYOBI y HOMELITE, no se requieren adaptadores. Para otras marcas, consulte la
  • Ryobi AC04141B | Operation Manual - Page 6
    USO DE ADAPTADORES Además del conjunto del cabezal de hilo Pro Cut II™ y la línea precortada de la recortadora, este paquete incluye los artículos que se mencionan a continuación, los cuales pueden utilizarse para adaptar el cabezal de hilo a las recortadoras que se incluyen en la tabla de
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
UNIVERSAL PRO CUT II
™
STRING HEAD
AC04141B
WARNING:
To reduce the risk of injury, user must read and under-
stand the operator’s manual for their string trimmer and
this instruction sheet. Always wear eye protection marked
to comply with Z87.1 Ensure compatibility and fit before
using this accessory. Do not use this accessory if a part
is damaged or missing.
When using RYOBI and HOMELITE string trimmers, no
adaptors are needed. For other brands, see the Adaptor
Chart for the proper hardware configuration needed to
use the Universal PRO CUT II
™
String Head with your
trimmer.
WARNING:
Failure to use the correct adaptor, nut, and spool retainer
combination for your trimmer could cause the string head
to detach from your trimmer and result in serious personal
injury and/or property damage.
INSTALLING STRING HEAD
See Figure 1.
Stop the engine and disconnect the spark plug wire.
Following the instructions in the operator’s manual for
your string trimmer, remove the old string head.
Install the string head on the drive shaft until fully
seated.
Install the spool retainer and tighten securely.
Install string as described in the next section.
INSTALLING STRING
See Figure 2.
Use monofilament string between .095 in. and .105 in.
diameter. Use original manufacturer’s replacement string
for best performance.
Stop the engine and disconnect the spark plug wire.
Gather two of the pre-cut lengths of trimmer line provided
or cut two pieces of trimmer line, in 11 in. lengths.
Insert the strings into the slots located on the sides of the
string head. String should be pushed in until approximately
1 in. protrudes from the holes on the top of the string
head.
Remove old string by pulling it from the holes located on
the top of the string head.
Fig. 2
Fig. 1
SPOOL
RETAINER
STRING
HEAD
DRIVE SHAFT
HOLE
SLOT
SLOT
INSERT STRINGS THROUGH SLOTS UNTIL
APPROX. 1 IN. PROTRUDES FROM HOLES
HOLE
PULL STRINGS
FROM HOLES
TO REMOVE
TECHTRONIC INDUSTRIES POWER EQUIPMENT
1428 Pearman Dairy Road
Anderson, SC 29625, USA
Phone 1-800-860-4050
www.ryobitools.com
991000971
6-8-16 (REV:01)
WARNING:
Do not remove screws or disassemble head. If head is
opened, compression springs may fly out toward operator
and result in serious injury.