Sanyo LNS-T02 Owners Manual
Sanyo LNS-T02 - Telephoto Zoom Lens Manual
 |
UPC - 086483037375
View all Sanyo LNS-T02 manuals
Add to My Manuals
Save this manual to your list of manuals |
Sanyo LNS-T02 manual content summary:
- Sanyo LNS-T02 | Owners Manual - Page 1
PROJECTOR LENS MODEL NO. LNS-W02/T02 LNS-W02K/T02K Series LENS REPLACEMENT AND INSTALLATION PROCEDURE NOTES ON LENS INSTALLATION Lens installation should be performed by the qualified service personnel. It should be followed by this procedure precisely. Before attempt to install the lens, confirm - Sanyo LNS-T02 | Owners Manual - Page 2
4. Remove screws C (2 screws) and remove upper lens cover. A D Fig-1 LOWER LENS COVER In case figure-2 cabinet. Remove 4 screws of the lens cover and remove the lens cover. LENS COVER 2 q IN CASE OF MODEL WITHOUT LENS REMOVE THE COVER PLATE OF THE LENS COVER. (See figure-3) Remove 2 screws and - Sanyo LNS-T02 | Owners Manual - Page 3
screws) which fastens the lens and remove the lens. Fig-4 C B LENS MOTOR LEAD CONNECTOR " K16B" LENS MOTOR (D) (D) A (D) (D) 3 INSTALL THE LENS. (See figure-4,5) 1. Remove protective caps (front and back ) on the lens. 2. Mount the lens at the lens mounting bracket with screws (4 screws - Sanyo LNS-T02 | Owners Manual - Page 4
. (See figure-7) When in install the both upper and lower lens UPPER LENS COVER covers, put the light-block sheet through the A lens and install the sheet so that it should be placed in the guide slot of the lens cover. (See figure-8) If the installation of the light-block sheet is incorrect
-
1 -
2 -
3 -
4
 |
 |
PARTS LIST
Following parts are contained in the packing.
·
LENS
·
LENS MOUNTING SCREWS
· DRIVER
·
LIGHT-BLOCK SHEET
·
LENS COVER (UPPER · LOWER )
NOTES ON LENS INSTALLATION
LCD PROJECTOR LENS
MODEL NO.
LNS-W02/T02
LNS-W02K/T02K Series
Lens installation should be performed by the qualified service personnel.
It should be followed by this procedure precisely.
Before attempt to install the lens, confirm the model number (both the LCD
projector and the lens) and use the proper lens.
If you have any questions, contact to the dealers.
Following checks and confirmations should be taken for safety.
Check the following things by the time of the cabinet assembly after the
lens installation.
1. Confirm the lens is securely fixed by 4 screws.
2. Wiring must not be tangled in the gear of the lens motor or the other
mechanical part.
3. There is no missing part, or no loosing mounting part.
1AA6P1P2289-- (ICSC)
1 piece
6 screws (2 for spare)
1 piece
1 sheet
1 set
LENS REPLACEMENT AND
INSTALLATION PROCEDURE