Sanyo LNSS01 Owners Manual

Sanyo LNSS01 - LNS S01 Zoom Lens Manual

Get Sanyo LNSS01 - LNS S01 Zoom Lens PDF manuals and user guides View all Sanyo LNSS01 manuals
Add to My Manuals
Save this manual to your list of manuals

Sanyo LNSS01 manual content summary:

  • Sanyo LNSS01 | Owners Manual - Page 1
    LCD PROJECTOR LENS MODEL NO. LNS-M01 LNS-S01 LENS REPLACEMENT AND INSTALLATION PROCEDURE NOTES ON LENS INSTALLATION Lens installation should be performed by the qualified service personnel. It should be followed by this procedure precisely. Before attempt to install the lens, confirm the model
  • Sanyo LNSS01 | Owners Manual - Page 2
    the light-block sheet, so that the large rounder side is set over the lens. SCREWS COVER PLATE Fig-2 q IN CASE OF MODEL WITH LENS p Figure shown inside of the cabinet. (D) REMOVE THE LENS. (See figure-3.) 1. Remove the connector "K16B" of the circuit board. 2. Loosen the A, B wire holder
  • Sanyo LNSS01 | Owners Manual - Page 3
    install the sheet so that it should be placed in the guide slot of the lens cover. If the installation of the light-block sheet is incorrect, there will be the space between lens and the lens cover, so that it will be the cause of leakage of light or the dust entering at
  • 1
  • 2
  • 3
PARTS LIST
Following parts are contained in the packing.
·
LENS
·
LENS MOUNTING SCREWS
· DRIVER
·
LIGHT-BLOCK SHEET
NOTES ON LENS INSTALLATION
LCD PROJECTOR LENS
MODEL NO.
LNS-M01
LNS-S01
Lens installation should be performed by the qualified service personnel.
It should be followed by this procedure precisely.
Before attempt to install the lens, confirm the model number (both the LCD
projector and the lens) and use the proper lens.
If you have any questions, contact to the dealers.
Following checks and confirmations should be taken for safety.
Check the following things by the time of the cabinet assembly after the
lens installation.
1. Confirm the lens is securely fixed by 4 screws.
2. Wiring must not be tangled in the gear of the lens motor or the other
mechanical part.
3. There is no missing part, or no loosing mounting part.
1AA6P1P1980-- (ICPP)
1 piece
6 screws (2 for spare)
1 piece
1 sheet
LENS REPLACEMENT AND
INSTALLATION PROCEDURE