Sealey CHARGE112 Instruction Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,

and properly maintained, give you years of trouble free performance.

1. SAFETY

1.1.

ELECTRICAL SAFETY

±

WARNING!

It is the user’s responsibility to check the following:

Check all electrical equipment and appliances to ensure that they are safe before using. Inspect power supply leads, plugs and

all electrical connections for wear and damage. Sealey recommend that an RCD (Residual Current Device) is used with all electrical

products. You may obtain an RCD by contacting your local Sealey dealer.

If the product is used in the course of business duties, it must be maintained in a safe condition and routinely PAT (Portable

Appliance Test) tested.

Electrical safety information, it is important that the following information is read and understood.

1.1.1.

Ensure that the insulation on all cables and on the appliance is safe before connecting it to the power supply.

1.1.2.

Regularly inspect power supply cables and plugs for wear or damage and check all connections to ensure that they are secure.

1.1.3.

Important

: Ensure that the voltage rating on the appliance suits the power supply to be used and that the plug is fitted with the

correct fuse - see fuse rating in these instructions.

8

DO NOT

pull or carry the appliance by the power cable.

8

DO NOT

pull the plug from the socket by the cable.

8

DO NOT

use worn or damaged cables, plugs or connectors. Ensure that any faulty item is repaired or is

replaced immediately by a qualified electrician.

1.1.4.

This product is fitted with a BS1363/A 13 Amp 3 pin plug.

If the cable or plug is damaged during use, switch off the electricity supply and remove from use.

Ensure that repairs are carried out by a qualified electrician.

Replace a damaged plug with a BS1363/A 13 Amp 3 pin plug. If in doubt contact a qualified electrician.

a) Connect the GREEN/YELLOW earth wire to the earth terminal ‘E’.

b) Connect the BROWN live wire to the live terminal ‘L’.

c) Connect the BLUE neutral wire to the neutral terminal ‘N’.

Ensure that the cable outer sheath extends inside the cable restraint and that the restraint is tight.

Sealey recommend that repairs are carried out by a qualified electrician.

1.1.5.

If an extension reel is used it should be fully unwound before connection. A reel with an RCD fitted is

preferred since any appliance plugged into it will be protected. The cable core section is important and should be at least 1.5mm², but

to be absolutely sure that the capacity of the reel is suitable for this product and for others which may be used in the other output sockets,

we recommend the use of 2.5mm² section cable.

1.2.

GENERAL SAFETY

▲

DANGER! BE AWARE, LEAD-ACID BATTERIES GENERATE EXPLOSIVE GASES DURING NORMAL BATTERY OPERATION.

FOR THIS REASON, IT VERY IMPORTANT TO READ AND FOLLOW THESE INSTRUCTIONS CAREFULLY, EACH TIME YOU USE

THE CHARGING EQUIPMENT.

1.2.1.

Follow these instructions and those published by the battery and vehicle manufacturers, and the maker of any equipment you intend to

use in the vicinity of the battery. Remember to review warning marks on all products and on engines.

±

WARNING!

Modern vehicles contain extensive electronic systems.

You are required to check with the vehicle Manufacturer, for any specific instructions regarding the use of this type of

equipment on each vehicle.

1.2.2.

No liability will be accepted for damage / injury, where this product is not used in accordance with all instructions.

1.3.

PERSONAL PRECAUTIONS

1.3.1.

Ensure there is another person within hearing range and close enough to come to your aid, should a problem arise when working near a

lead-acid battery.

9

Wear safety eye protection and protective clothing. Avoid touching eyes while working near battery.

9

Have fresh water and soap nearby in case battery acid contacts skin, clothing or eyes.

9

Wash immediately with soap and water if battery acid contacts skin or clothing. If acid enters eye, flush eye immediately with cool, clean

running water for at least 15 minutes and seek immediate medical attention.

9

Remove personal metallic items such as rings, bracelets, necklaces and watches. A lead-acid battery can produce a short-circuit current

which is high enough to weld a ring or the like to metal, which would cause severe burns.

9

Ensure hands, clothing (especially belts) are clear of fan blades and other moving or hot parts of engine, remove ties and contain long hair.

8

DO NOT

smoke or allow a spark or flame in the vicinity of battery or engine.

C

HARGE106.V3, 107.V3, 110.V3, 112.V3, 115.V3, 124.V3 | Issue:1 10/11/17

Original Language Version

© Jack Sealey Limited

W

ear

Protective

Gloves

W

arning:

Electricity

Protect

From

Rain

U

se in

W

ell

V

entilated

Areas

Keep away

from sources

of ignition:

B

attery could

explode

Refer to

Instruction

Manual

W

arning:

Explosive

Material

W

ear eye

Protection

W

arning:

Corrosive

substance

INSTRUCTIONS FOR

BATTERY CHARGERS 8/11/14/16/19/28AMP 230V

MODEL NO:

CHARGE 106.V3/107.V3/110.V3/112.V3/115.V3/124.V3

Recommended fuse rating

13 Amp

Sealey CHARGE112 Instruction Manual

Sealey CHARGE112 Manual

Sealey CHARGE112 manual content summary: