Sharp KB-3300JW Installation Manual
Sharp KB-3300JW Manual
 |
View all Sharp KB-3300JW manuals
Add to My Manuals
Save this manual to your list of manuals |
Sharp KB-3300JW manual content summary:
- Sharp KB-3300JW | Installation Manual - Page 1
WITH MICROWAVE DRAWER 30" Freestanding Range INSTALLATION MANUAL SPECIAL WARNING INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER. IMPORTANT: SAVE THIS INSTALLATION MANUAL FOR LOCAL ELECTRICAL INSPECTOR'S USE. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. CLEARANCES - Sharp KB-3300JW | Installation Manual - Page 2
instructions with the consumer. IMPORTANT NOTES TO THE CONSUMER Keep this manual with your Operation Manual for future reference. • As when using any range Manual. Read all and follow carefully. • Be sure your range is installed and grounded properly by a qualified installer or service technician - Sharp KB-3300JW | Installation Manual - Page 3
excess spillage. Follow the precleaning instructions in the Operation Manual. ELECTRICAL CONNECTIONS To reduce the risk of tipping the range, it must be secured by , title 24CFR, part 3280 [Formerly the Federal Standard for Mobile Home Construction and Safety, title 24, HUD (part 280)] or when - Sharp KB-3300JW | Installation Manual - Page 4
INSTALLATION MANUAL 208/240 VOLT CONNECTION INSTRUCTIONS The range can be set for 208V or 240V. Thescvreowltage settin1g80˚for your range is pre-set at 240V from the factory. Follow these steps to change the voltage setting. 1 Locate the voltage switch on the lower back side of the range. 2 Remove - Sharp KB-3300JW | Installation Manual - Page 5
the rear access cover. See Figure 7. GROUNDING INSTRUCTIONS- ONLY 3-WIRE CONNECTIONS: A ground strap is installed on this range which connects the center terminal of the neutral terminal block to the range chassis. The ground strap is connected to the range by the center, lowest screw. See Figure - Sharp KB-3300JW | Installation Manual - Page 6
INSTALLATION MANUAL ADJUSTABLE BACKSPLASH The range backsplash is adjustable so that you can into the back cover. Rubber Gasket End cap Parts Supplied 4 Screws 1 Backsplash 1 Rubber Gasket IMPORTANT This backsplash must be installed before the range is moved into place. 3 Carefully pull each - Sharp KB-3300JW | Installation Manual - Page 7
INSTALLATION MANUAL ANTI-TIP NORMAL INSTALLATION STEPS ANTI-TIP BRACKET INSTALLATION INSTRUCTIONS IMPORTANT SAFETY WARNING To reduce the risk of tipping of the range, the range must be secured to the floor by properly installed Anti-Tip bracket and screws packed with the range. Failure to install - Sharp KB-3300JW | Installation Manual - Page 8
in your Operation Manual for our toll-free service number and address. Please call or write if you have inquiries about your range product and/or need to order parts. NOTE Please do not open or close the lower oven door for 30 seconds after plugged in. TINSEB390MRR0 SHARP ELECTRONICS CORPORATION
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
 |
 |
1
INSTALLATION MANUAL
SPECIAL WARNING
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.
IMPORTANT: SAVE THIS INSTALLATION MANUAL FOR LOCAL ELECTRICAL
INSPECTOR’S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
CLEARANCES & DIMENSIONS
For SAFETY CONSIDERATIONS do not install a range in any combustible cabinetry which is not in
accord with the stated clearances and dimensions on page 2. See Figures 1 and 2.
CLEARANCES AND DIMENSIONS
..............................
2
IMPORTANT NOTES
.............................................
3
IMPORTANT SAFETY INSTRUCTIONS
.........................
3
ELECTRICAL CONNECTIONS
................................
3-5
BACKSPLASH INSTALLATION
..................................
6
ANTI-TIP
.......................................................
7
MODEL AND SERIAL NUMBER
.................................
8
CARE, CLEANING AND MAINTENANCE
......................
8
E
LECTRIC
R
ANGE
W
ITH
M
ICROWAVE
D
RAWER
30” Freestanding Range