TASCAM IF-FW/DM :DM Owners Manual
TASCAM IF-FW/DM Manual
View all TASCAM IF-FW/DM manuals
Add to My Manuals
Save this manual to your list of manuals |
TASCAM IF-FW/DM manual content summary:
- TASCAM IF-FW/DM | :DM Owners Manual - Page 1
» D00830000B IF-FW/DM FireWire Interface Card OWNER'S MANUAL - TASCAM IF-FW/DM | :DM Owners Manual - Page 2
OUTPUTS 8 DM-3200 8 DM-24 9 MIXER INPUTS 9 DM-3200 9 DM-24 9 THE IF-FW/DM CONTROL PANEL (WINDOWS 10 ENABLE WDM 11 Introduction Thank you for purchasing the TASCAM IF-FW/DM FireWire audio card for TASCAM mixers. It is designed to provide audio and MIDI interfacing between your TASCAM mixer - TASCAM IF-FW/DM | :DM Owners Manual - Page 3
IntroductioOn Features The IF-FW/DM provides the following interfacing between your TASCAM mixer and a host computer via FireWire: • 24 channels of Input to the mixer from the computer at 44.1k and 48k sample rates • 24 channels of Output from the mixer to the computer at 44.1k and 48k sample - TASCAM IF-FW/DM | :DM Owners Manual - Page 4
force is not required - if it does not click in easily, remove it and TASCAM IF-FW/DM Owner's Manual start again with attention to the guides. 3. Replace the five screws to hold the card in place. NOTE • The IF-FW/DM must be installed in to the mixer's Slot 1. It will not function in Slot - TASCAM IF-FW/DM | :DM Owners Manual - Page 5
is necessary to add a FireWire card, thus adding a separate bus, for those devices. • The maximum FireWire cable length is 3 meters. Configuring the Computer Macintosh The IF-FW/DM uses the FireWire audio/ MIDI services provided by OSX, so it is not necessary to install drivers. You must have OSX - TASCAM IF-FW/DM | :DM Owners Manual - Page 6
present a "Finished" message. Click Exit. 10. Your IF-FW/DM is installed and ready to use. Windows 64-Bit Windows driver version 1.10 & higher includes untested 64-bit drivers (requires 64-bit PC hardware and 64-bit Windows OS). This is not officially supported. TASCAM IF-FW/DM Owner's Manual - TASCAM IF-FW/DM | :DM Owners Manual - Page 7
SetuOp IF-FW/DM Interface Setup Below are brief instructions for setting up common DAW software applications to use the IF-FW/DM interface. If your application is not covered here, but does support ASIO (PC), WDM (PC) or Core Audio (Mac), or if Cubase / Nuendo 1. Select Device Setup under the - TASCAM IF-FW/DM | :DM Owners Manual - Page 8
disconnection and reconnection of the FireWire cable. clocked to an external source other than the DAW. 96 k & 88.2 k Operation The IF-FW/DM does not support these sample rates. IF-FW/DM & Mixer Routing The IF-FW/DM appears to a mixer just like any other optional I/O card except that it has Mixer - TASCAM IF-FW/DM | :DM Owners Manual - Page 9
the CH1-16 IN and CH17-24 IN tabs of the mixer's I/O screen. For 24 channel operation: • Set RETURN CH1-8 to A:SLOT1, Trk1-8, FW 1-8 • Set RETURN CH9-16 to B:SLOT1, Trk9-16, FW 9-16 • Set RETURN CH17-24 to A:SLOT1, Trk17-24, FW 17-24 Set the INPUT SOURCE to RETURN TASCAM IF-FW/DM Owner's Manual - TASCAM IF-FW/DM | :DM Owners Manual - Page 10
settings that are too low for a particular computer is clicks & pops in the audio. 10 TASCAM IF-FW/DM Owner's Manual The three sliders are: Stream buffer depth Use this slider to control the size of the incoming or clock source for the mixer is changed without removing the FireWire cable first. - TASCAM IF-FW/DM | :DM Owners Manual - Page 11
that cannot use ASIO and you want to access all 24 channels of audio, click this option. It may take 1 to 2 minutes for Windows to finish reconfiguring with a total of 12 stereo pairs of WDM audio. This affects the start-up time of the computer as well. Setup TASCAM IF-FW/DM Owner's Manual 11 - TASCAM IF-FW/DM | :DM Owners Manual - Page 12
» IF-FW/DM TEAC CORPORATION Phone: +81-422-52-5082 www.tascam.com 3-7-3, Nakacho, Musashino-shi, Tokyo 180-8550, Japan TEAC AMERICA, INC. Phone: +1-323-726-0303 www.tascam.com 7733 Telegraph Road, Montebello, California 90640 TEAC CANADA LTD. Phone: +1905-890-8008 Facsimile: +1905-890-9888
ยป
D00830000B
OWNER'S MANUAL
IF-FW/DM
FireWire Interface Card